User manual SANYO CWM-480 INSTRUCTION MANUAL

[. . . ] SOME STATES DO NOT ALLOW LIMITATIONS ON HOW LONG AN IMPLIED WARRANTY LASTS AND/OR DO NOT ALLOW THE EXCLUSION OR LIMITATION OF CONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATIONS AND EXCLUSIONS MAY NOT APPLY TO YOU. R97/10/20(M) For your protection in the event of theft or loss of this product, please keep the following information with a sales receipt in a safe place. Where Purchased Date of Purchase SANYO Manufacturing Corporation -E1- CWM-460/US 2 28/11/2002, 16:28 CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO PREVENT THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). This symbol indicates that dangerous voltage constituting a risk of electric shock is present within this unit. [. . . ] If water should enter the unit, electrical shock or a malfunction may result. Do not use the unit in areas where extremes in temperature occur (below 40°F or exceeding 95°F), or where it may be exposed to direct sunlight. Because of the CD player's extremely low noise and wide dynamic range, there is a tendency to turn the volume on the amplifier higher than necessary. Doing so may produce an excessively high output from the amplifier which can cause damage to your speakers. Sudden changes in the surrounding temperature can cause dew to form on the optical pickup lens inside the unit. If this should occur, remove the disc and allow the player to adjust to the surrounding temperature. · -E3- CWM-460/US 4 28/11/2002, 16:28 SPEAKER SYSTEM CONNECTIONS To detach the speaker enclosures To attach the speaker enclosures -E4- CWM-460/US 5 28/11/2002, 16:28 AC power operation Take out the cord and connect it. CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT. ATTENTION: POUR ÉVITER LES CHOC ÉLECTRIQUES, INTRODUIRE LA LAME LA PLUS LARGE DE LA FICHE DANS LA BORNE CORRESPONDANTE DE LA PRISE ET POUSSER JUSQU AU FOND. 120V AC, 60Hz NOTE: · This unit is equipped with a polarized plug. If you have difficulty in inserting the plug, turn it over and reinsert it. · When the AC power cord is connected to the unit, the installed batteries will be automatically disconnected. -E5- CWM-460/US 6 28/11/2002, 16:28 POWER SUPPLY Battery power operation Install batteries. Observe + and ­ signs. 8 "D" size batteries (not supplied) CAUTION: WHEN INSTALLING THE BATTERIES To prevent leakage from the batteries, which is corrosive and can cause personal injury and damage to the unit, observe the following precautions: 1. Press [PLAY/PAUSE] again to resume play. Search (forward/reverse) 1. If [SKIP/SEARCH] h or g is pressed during play, the player search at high speed in the forward or reverse direction while the button is being pressed. NOTE: If [SKIP/SEARCH] h or g is pressed during the PAUSE mode, no sound will be heard, and the PAUSE mode will continue when the button is released. Press and hold down during playback. Skip play 1. To skip to track 6 while track 3 is playing, press [SKIP/SEARCH] g repeatedly until "6" appears in the track section on the display. To skip back to track 3 while track 6 is playing, press [SKIP/ SEARCH] h repeatedly until "3" appears. NOTE: If [SKIP/SEARCH] h or g is pressed while the unit is in the PAUSE mode, the unit will remain in the PAUSE mode when the button is released. Press and release repeatedly. -E11- CWM-460/US 12 28/11/2002, 16:28 PROGRAMMED PLAY TO PROGRAM 3 1 2, 4 With programmed play, up to 20 tracks on a disc can be memorized and played in any order. 5 6 Repeat 3 and 4 to memorize additional tracks. Checking the program Press [MEMORY] repeatedly in the stop mode. In the stop mode, press [MEMORY] repeatedly until "-- -- --" appears. The preset station are selected in sequenced for approximately five seconds each. PRESET 3 Press [PRESET] when the desired station has been selected. Preset scanning will stop. PRESET -E16- CWM-460/US 17 28/11/2002, 16:29 CASSETTE TAPE OPERATION PLAYBACK 14 4 To control the sound. 32 1 Set to [TAPE]. 2 Press [STOP/EJECT] once to stop the tape. Insert a cassette. Pause Press [PAUSE] to temporarily stop playback or recording. When the desired location or the end of the tape is reached, press [STOP/EJECT]. [. . . ] · When [REC] is pressed, recording will start at the beginning of track number 1 of the disc. · If a program has been entered, recording will start from the beginning of the first programmed track. -E19- CWM-460/US 20 28/11/2002, 16:29 B REMOTE CONTROL OPERATION NOTE: The buttons on the remote control perform similar functions to similarly marked buttons on the front panel. CD player section (In CD function mode) Start play i Temporarily stop play i Select the desired track e or f (or Number buttons) Search During play e or f (press continuously) Skip During play e or f (press once. ) Repeat play Stop REPEAT/FM MODE v i n Tuner section (In RADIO function mode) Select band BAND Station e/TUNING +or f/TUNING ­ Manual tuning: Press repeatedly Automatically tuning: Press and hold for 1 second. Select preset station Preset scan tuning Select FM mode PRESET (or Number buttons) PRESET (Hold for at least 1 second) v PRESET REPEAT/FM MODE CWM-460/US 21 v Preset station "Station tuning" v MEMORY v v MEMORY PRESET (or Number buttons) v Programmed play MEMORY v v MEMORY v i e or f (or Number buttons) -E20- 28/11/2002, 16:29 MAINTENANCE Cleaning the unit Clean the outside of the unit with a clean soft cloth, moistened with lukewarm water. [. . . ]