User manual SANYO CLT656

[. . . ] INSTRUCTION MANUAL CLT-9923 CLT-9926/9926W CLT-9936/9936G Main Features 900-MHz Technology Extended Range -The use of 900-MHz frequency band for signal transmission between base and handset means greater communication range compared to conventional 43 ­ 49 MHz cordless telephones. Ultra-Low Noise -The high frequency communication has also significantly reduced noise level. 40-Channel Auto/Manual Scan -Your new telephone uses one of 40 channels in the 900-MHz frequency band. It automatically selects a clear channel every time you receive or place a call on the handset. [. . . ] · Press the CID/VOL to scroll through the list from the oldest to the most recent. Transferring Caller ID entries to the directory You can transfer up to 10 Caller ID entries to your phone's directory. Use the CID/VOL keys to scroll to the call entry you want to transfer to the directory. Note: Before transfering a caller ID number, make sure the number appears in proper digits for your dialing area. For example, if the caller ID number appears 1-416-222-5555 but it is not a long distance number, press the 7-10-11 key until it shows 416-222-5555 (without 1). Caller ID number display The 7-10-11 key lets you select how many digits of the number to be displayed. 11 Long distance code 1 + 3-digit area code + 7-digit telephone number. · Use the CID/VOL keys to scroll to the phone number you want to store or call back. · Press the 7-10-11 key to change to the required number of digits. To replace a name/number stored in the directory with a new call entry: 1. Press TONE/CANCEL to exit, or press MEM again and the new call entry number replaces the current name/number in that memory location. ENTER NAME Prompt telling you to enter the name for one of 10 directory locations. ENTER TEL NUMBR Prompt telling you to enter the telephone number for one of 10 directory locations. Prompt asking if you want to erase an entry in the Caller ID list or directory. END OF LIST Indicates that there is no additional information in Caller ID list. UNKNOWN NAME/CALLER/NUMBER The incoming call is from an area not serviced by Caller ID or the information was not sent. BLOCKED CALL The caller has blocked name/number from transmission. 1. Tip: Wait for the access tones between pressing MEM, or your call might not go through. CLT-9923-26-36E 3/14/03 4:05 PM Page 5 BLOCKED NAME The caller's name is blocked from transmission. Indicates that a new call from the same number was received more than once. MESSAGE WAITING This appears for 60 seconds when you have just received a new voice mail. This message only appears if you subscribe to an answering service with your telephone company. MSG WAITING OFF Appears when Voice Mail has been reviewed. · See solutions for No dial tone. [. . . ] The equipment must also be installed using an acceptable method of construction. In some cases, the company's inside wiring associated with single-line individual service may be extended by means of a certified connector assembly (telephone extension cord). The customer should be aware that compliance with the above conditions may not prevent degradation of service in some situations. Repairs to certified equipment should be made by an authorized Canadian maintenance facility designated by the supplier. [. . . ]