User manual SANYO CDP-M420

[. . . ] 5V socket, then plug the other end into an AC 230V, 50 Hz wall outlet. notes on alkaline batteries · When replacing the batteries, use four new batteries of the same type. Do not mix used battery with new one or mix different types of batteries. [. . . ] (Note: The unit cannot play back the music files added with "Track-at-Once". ) Music files recorded by "Packet Writing" cannot be played back. Some MP3 CDs can not be played back depending on the recording conditions. The CD-R/RW that has no music data or non-MP3 files can not be played back. Anti rolling shock function In the previous anti-shock function, when skips occurred while available memory runs out, then the sound would suffer some interruption. The new anti rolling shock function is designed to prevent skipping to the greatest extent possible instead of supplementing the skipped portion of the sound. This is achieved by expanding the memory capacity, and in addition full attention has been given also to increasing the unit's signal reading capability. Moreover, consideration has been given to eliminating the basic causes of skipping, both from the standpoint of horizontal shock and vertical shock. When the i button is pressed first time, the anti rolling shock function turns on automatically. Then "ESP" is remain standby when the buffer memory is full of next 45 seconds music data to Music CD and full of next 120 seconds music data to MP3 CD. Sound may skip or mute for a few seconds when you press the ALBUM/ASR button during play. Playing may stop when the unit gets strong shock even when the anti rolling shock function is on. When playing back MP3 CD, this function always works even if "ESP" doesn't appear. Auto power on function The power turns on automatically when i button is pressed. Auto power off function The power turns off automatically after about 60 seconds when all tracks on a disc have been played or when the n button is pressed once to stop play. 5) The HOLD switch disables the buttons from operating to prevent play from starting or stopping due to accidental operation. [. . . ] During play press the MODE button four times, "RAND" blinks, "RAND" remains lit when second track begins to play. In the stop mode, press the PROG button repeatedly until the track number to be replaced is displayed. The programmes will be lost after turn off the power or the disc compartment is opened. [. . . ]