User manual SANYO AWM-660

[. . . ] INSTRUCTION MANUAL AWM-660 Micro Component System 1 4 7 0 2 5 8 FM MODE /REPEAT 3 6 9 TUNER /BAND REMOTE CONTROLLER RB-MCR60 CONTENTS Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Accessories . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Safety certification . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Connections . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Do not apply paper or write anything on either side of the compact disc. Sharp writing instruments, or the inks used in some felt-tip pens, may damage the surfaces of the disc. This unit can play back the CD-R/RW that have recorded music data as well. However, some CD-R/RWs can not be played back depending on the recording conditions. · · Fingerprints and dust should be carefully wiped from the signal surface of the disc (glossy side) with a soft cloth. Never use chemicals such as record cleaning sprays, antistatic sprays or fluids, benzene or thinner to clean compact discs. These chemicals will permanently damage the plastic surface of the disc. Always place the compact disc on the disc turntable with the label facing toward you. To remove a disc from its storage case, press down on the center of the case and lift the disc out, holding it carefully by the edges. · · · IMPORTANT INFORMATION Sanyo CD players have built-in error compensation circuits to correct for minor manufacturing defects in a disc, There are limits, however, to the amount of correction possible. In some cases, the CD player may skip some tracks on a disc during play. This problem may be caused by defects (such as scratches) in the disc being played, which are too large for the error compensation circuits to handle. If you encounter this problem, check the operation of the CD player as follows, before having the unit serviced. If the CD player operates normally, the skipping problem is most likely due to a defective disc. CD PLAY NOTES: · Never place anything except a compact disc on the disc turntable. If a disc is loaded, you can turn the unit on and begin play immediately by pressing [I]. Place the disc with the label facing toward you on the disc turntable. (Place only one disc at a time. ) For 5-inch (12cm) or 3-inch (8cm) CD BASIC CD PLAY 2 3 5 6 1 4. Push the CD door back into position until it "clicks" into place. NOTE: If the disc is loaded with the label facing toward the unit, or if a badly scratched disc is loaded, "Cd" appears. The CD door opens. The current track number and elapsed playing time are displayed. When the last track has been played, the player stops automatically. CAUTION: Please do not place anything in front of the unit. In such a case, the object in front of the unit may fall over or be knocked down. -E8- AWM-660/US Eng page 9 4/16/04, 5:40 PM PROGRAMMED PLAY Up to 20 tracks on a disc can be programmed for play in any order. · First, select the "CD" function and load a disc that you want to program. Press [MEMORY]. F I N E IMPORTANT NOTE: Opening the CD door while a disc is playing could scratch the disc. [. . . ] There are 12 time periods available: 120, 110, 100, 90, 80, 70, 60, 50, 40, 30, 20, and 10 minutes. "SLEEP" blinks and the selected time appears on the display. "SLEEP" blinks. To check the remaining sleep time Press [ SLEEP ] only once. To release the sleep timer while in operation Press [ SLEEP ] repeatedly until "SLEEP" disappears. [. . . ]