User manual SANWA SUPER EXZES

[. . . ] Remove the 4mm hex socket head cap screws on each side of the transmitter using a 3mm hex wrench. Be careful to avoid damaging the lead wires that are connected on both units. There are four (4) Phillips screws holding each side of the grip bracket. Remove the screws and reset the bracket screw hole at the lower screw hole. [. . . ] To copy data from the current selected (Master) model to another model (Slave), use the INC/+ or DEC/- keys to change the model numbers up or down to the model number you would like to copy the current model (Master) to. After you have selected the model number you wish to copy the current model (Master) to, press the ENTER key. The screen will now change and ask you: YES=<INC> and NO=<DEC> Press the INC/+ key to copy the current (Master) model to the new model (Slave) you have selected. To copy data from another model to the one you are currently using, use the key to change the current model (Master) to (Slave). Select the model (Master) you want to copy from using the Inc. + or Dec. - keys and then press the ENTER key. A confirmation screen appears, allowing you to confirm that choice is correct. Using the function select keys, move the cursor to [COPY/CLEAR] in MODEL. Press both INC/+ or DEC/- keys simultaneously to select the (- - -:CLEAR) model. Select yes to clear the current model or no to return to the previous screen. NOTE: CLEAR can be selected by simultaneously pressing Inc/+ and Dec/-. appears until operation is completed. Page 24 Sub-Trim This feature corrects trim neutral for steering and throttle, making it possible to use the main trim from the center position. The timers appear in the timer display area in the order FUNC1>FUNC2>FUNC3, as set with the key assign switch. CAUTION When measurement is started, the previous LAP measurement is cleared. To re-start the timer, turn it ON as described in step 2). Pointer revolves while timer running FUNC1 FUNC2 FUNC3 Timer display area (*LAP) Page 27 Timer (Cont) [INT] Interval Timer The interval timer notifies you when a set interval elapses while you are driving, giving you an idea how close you are to your target time. Interval timers are provided separately for minutes and seconds, and both can be used simultaneously. Make sure that the cursor appears below LAP, and then press Inc. + or Dec. - to set the timer ON or OFF. Setting the interval minute timer (MIN) 3. Press the ENTER key to move the cursor to the right of MIN, and then set the timer by pressing the Inc. + or Dec. - key. The interval minute timer will not function when it is set as 00'. Setting range 00' to 99' (Default setting 00') Setting the interval second timer (SEC) 4. Press the ENTER key to move the cursor to the right of SEC, and then set the timer by pressing the Inc. + or Dec. - key. Setting range 00" to 59" (Default setting 00') 1/10-Seconds Setting 5. Press the ENTER key to move the cursor to the left of 00", and then set the timer by pressing the Inc. + or Dec. - key. [. . . ] Turn on the Display switch of the SUPER EXZES than turn on the Power of the ESC `s switch harness. Ready for DSC operation. CAUTION Never turn on the transmitter power switch while using the DSC harness. When using the DSC cable, connect the power battery to the E/P car and/or connect the receiver battery to receiver for G/P models. When using the DSC cable, be certain that the transmitter battery is installed. [. . . ]