User manual SANUS VMDD26

[. . . ] All other brand names or marks are used for identification purposes and are trademarks of their respective owners. EN Do not use this product for any purpose not explicitly specified by Sanus Systems. [. . . ] Tighten the lag bolts [11] only until the washers [12] are pulled against the wall plate [01]. EN TV with flat back Determine the diameter of the screw your TV requires by hand threading them into the threaded insert on the back of the TV. verify that there are adequate threads to secure the brackets to the monitor. If you are unsure which hardware to use, contact Customer Service for assistance. EN TV with curved back or obstruction near threaded insert Determine the diameter of the screw your TV requires by hand threading them into the threaded insert on the back of the TV. verify that there are adequate threads to secure the brackets to the monitor. If you are unsure which hardware to use, contact Customer Service for assistance. The vise assembly [06] must rotate freely around the carriage bolt [13]. Remove the safety bracket [B] only to adjust the swivel tension nut [C]. Be sure to replace the safety bracket after adjusting the swivel tension nut. The hex hole in the safety bracket must seat over the swivel tension nut. Do not remove the adjustment nut [E]; tighten or loosen only as necessary for easy arm adjustment. [. . . ] milestone makes no representation of warranty , expressed or implied , regarding the information contained herein. Milestone assumes no responsibility for accuracy, completeness or sufficiency of the information contained in this document. [. . . ]