User manual SANUS VLT15

[. . . ] Do not use this product for any purpose not explicitly specified by Sanus Systems. If you do not understand these directions, or have doubts about the safety of the installation, contact Customer Service or call a qualified contractor. sanus Systems is not responsible for damage or injury caused by incorrect mounting , assembly , or use. [. . . ] EN Supplied Parts and Hardware Before starting assembly, verify all parts are included and undamaged. If any parts are missing or damaged, do not return the item to your dealer; contact Sanus Systems Customer Service. Tighten the lag bolts [04] only until the washers [05] are pulled against the wall plate [01]. Tighten the lag bolts [04] only until the washers [05] are pulled against the wall plate [01]. The VLT15 brackets are configured, depending on TV thickness, to optimize the tilt of your TV. To achieve optimal tilt, measure the thickness of your TV and then adjust the bracket's tilt setting as follows: If your TV is greater than or equal to 50. EN Adjust the tilt setting by turning the tilt optimizer knobs [D] approximately 5 complete rotations. NOTE: To ensure that your TV is balanced, turn the tilt optimizer knobs [D] on both monitor brackets [02]/[03] the same number of rotations. Install Brackets Determine the bolt diameter for your monitor and your TV type. If you need extra space to accommodate cables, recesses, or protrusions, see an installation option (3-2 or 3-3) that uses spacers. Install the brackets as close to the bottom of the TV as possible to ensure that the TV tilts properly. Use the shortest screw and spacer combination needed to accommodate cables, recesses, or protrusions. Using hardware that is too long may damage your monitor's internal components. 1 To place your TV in the ClickStand position, simultaneously pull release cords down and TV out. 2 To place your TV back in the secure position, push ClickStands up and TV in. To remove the TV from the wall plate, simultaneously pull release cords down and TV out, and then lift the TV up and out away from the wall. [. . . ] The information contained in this document is subject to change without notice or obligation of any kind. milestone makes no representation of warranty , expressed or implied , regarding the information contained herein. Milestone assumes no responsibility for accuracy, completeness or sufficiency of the information contained in this document. [. . . ]