User manual SANUS VLF220

[. . . ] EN IMPORTANT SAFETY INSTRUCTIONS - SAVE THESE INSTRUCTIONS Thank you for choosing the Sanus VLF220 wall mount. The Sanus VLF220 wall mount is designed to support a monitor weighing up to 59 kg (130 lbs). [. . . ] Supplied Parts and Hardware EN Before starting assembly, verify all parts are included and undamaged. If any parts are missing or damaged, do not return the item to your dealer; contact Sanus Systems Customer Service. Tighten the lag bolts [26] only until the washers [25] are pulled against the wall plate [02]. Be sure that the center column is aligned with the center of the monitor. If you need extra space to accommodate cables, recesses, or protrusions, see an installation option (4-2 or 4-3) that uses spacers. CAUTION: Use the shortest screw and spacer combination needed to accommodate cables, recesses, or protrusions. Using hardware that is too long may damage your monitor's internal components. EN For TVs with 400 x 400mm spacing, remove the support tubes and release the locking carriages (c) before completing the bracket attachment step. After the brackets are attached to the TV, then resecure the locking carriages (c) and insert the support tubes. EN Be sure that the center column is aligned with the center of the TV. Tighten the EN tension adjustment [T] to prevent the arms from moving while installing the monitor bracket. EN Remove the arm covers by pressing the front of the cover; the rear of the cover will pop upward. Pull each arm to its full extension then route the cables through the arm. Leave enough slack to prevent stretching the cables when the arm is moved. [. . . ] milestone makes no representation of warranty , expressed or implied , regarding the information contained herein. Milestone assumes no responsibility for accuracy, completeness or sufficiency of the information contained in this document. [. . . ]