User manual SANUS VISIONMOUNT PULL OUT CABINET MOUNT-VMPO1

[. . . ] Assembly Instructions for Model: VMPO Thank You for your purchase of a Sanus Systems Vision Mount!The VMPO is designed to securely attach a Flat Panel LCD to a cabinet or an armoire. [. . . ] Using a Drill and a 1/4" Drill Bit, drill a hole in each marked location (6 total) in the Shelf. You should have 6 drilled holes that match the pattern shown in Diagram 1. Note: Diagram 1 is a Cutaway View Diagram 1 Mounting Surface Hole Pattern WARNING: It is the responsibility of the installer to verify the surface the VMPO is mounted to is secured so that it will NOT tip forward when the television is pulled out into its extended position. The mounting surface must be capable of supporting 5 times the total weight of the television and the mount. Step 2: Attach Glides to Mounting Surface To mount the Glides (k, l), insert a Button Head Bolt (a) through each indicated hole in the wood portion of the Glide, the Shelf you are mounting the VMPO to, a Washer (c), and finally thread a 1/4 20 Nut (b) onto the end. Repeat the process until all 3 Button Head Bolts are fastened securely on each Glide. Note: Make sure the end of the Glide with a Dowel is facing the front of the Shelf. Detailed View Diagram 2 a k mounting surface c b Step 3: Reposition the Dowels (optional) To have the VMPO extend further, simply remove the Dowels by lifting them out of the Glides (k, l) and placing them in the front hole location as shown in Diagram 3. Note: Sanus Always recommends fastening the cabinet or armoire to the wall!If you choose to remove this Dowel, it is the responsibility of the installer to verify the mounting surface is capable of supporting the weight of the television in the fully extended position. Diagram 3 Dowel k l front location Step 4: Attach Top Assembly to Glides Orient the Base (j) so that the 4 small holes face the front and the side with the long grooves faces down. Then orient the Top Assembly (m) so that the vertical tube is closer to the back. Insert a Furniture Bolt (g) through the Top Assembly, the Base, and finally thread it into the Glide (k, l). [. . . ] Step 9: Attach the VMPL50 Wall Plate to Top Assembly Insert a M8 Bolt (c) through the appropriate hole in the VMPL50 Wall Plate, the Top Assembly (m), the M8 Lock Washer (f), and thread it into a M8 Nut (d). Note: Proceed to follow the instruction manual that came with the VMPL50 Wall Mount to attach the Television to the wall plate. Diagram 9 d f e m VMPL50 Wall Plate Sanus Systems 2221 Hwy 36 West, Saint Paul, MN 55113 4. 05. 05 Customer Service: 800. 359. 5520. [. . . ]