User manual SANUS VISIONMOUNT LCD WALL MOUNT-MF110

[. . . ] Check carefully to make sure that there are no missing or defective parts. Sanus Systems can not be liable for damage or injury caused by incorrect mounting, incorrect assembly, or incorrect use. Please call Sanus Systems before returning products to the point of purchase. [. . . ] Attach the Wall Plate to the wall using three Lag Bolts (P) and three Lag Bolt Washers (Q). Make sure the Wall Plate is oriented so the flat surface in the center of the plate is against the wall. NOTE: The TV will be vertically centered on the Wall Plate once it is mounted. A Step 2: Add Arm Assembly to a television with a flat back NOTE: If your television has a curved back, or any other obstruction, proceed directly to Step 3. First, determine the diameter of the Bolt (C, D, E) your TV requires by hand threading them into the threaded insert on the back of the TV. Once you have determined the correct diameter, see the appropriate Diagram below. You will thread the Bolt through the appropriate Lock Washer (I, J, K), a Washer (N, O), the Monitor Plate, and finally thread it into the TV. Proceed to tighten all four Bolts until tight with a phillips screw driver. NOTE: Arm has been cutaway in this Step to show critical parts. M5 Diameter Bolt N M6 Diameter Bolt J D O K E M4 Diameter Bolt N I C Step 3: Add Arm Assembly to a television with a curved back, recessed area around the threaded inserts or any other obstruction. First, determine the diameter of the Bolt (F, G, H) your TV requires by hand threading them into the threaded insert on the back of the TV. Once you have determined the correct diameter, see the appropriate Diagram below. You will thread the Bolt through the appropriate Lock Washer (I, J, K), a Washer (N, O), the Monitor Plate, the appropriate Spacer (L, M) and finally thread it into the TV. M5 Diameter Bolt L N J G M M6 Diameter Bolt O K H M4 Diameter Bolt L F N I Step 4: Hang Arm Assembly on Wall Plate CAUTION: This step may require two people to lift the assembly onto the Wall Plate. Sanus Systems is not responsible for property damage and/or personal injury. [. . . ] Leave some slack in the cables so that during motion so there is no added tension on the connectors. Wire Tie Clips (R) can be attached to the holes in the top and the bottom of the Arm Assembly (B) by simply pressing them into place as shown in the Detailed View of Diagram 7. and its affiliated corporations and subsidiaries (collectively, "CSAV"), intend to make this manual accurate and complete. [. . . ]