User manual SANUS VISIONMOUNT IN-WALL MOUNT-LRF118

[. . . ] The Sanus Systems LRF118 wall mount is designed to support a monitor sized up to 50 in. This product must be used with the Sanus Systems LR1A, sold separately. [. . . ] If you have any doubts about the ability of the wall to support the monitor, contact Sanus Customer Service, or a qualified contractor. 1-2: Attach brackets to monitor, for monitors with a curved back or obstruction. The vise assembly [04] must rotate freely around the carriage bolt [13]. Install the preventer [08] on the left side if you want the arm to fold to the left. NOTE: Refer to the instructions included with the LR1A for proper installation of the wall mount [a]. Refer to the instructions included with the LR1A for proper installation of the safety fasteners [a], [B], and [C]. NOTE: Be sure to leave enough slack in the cables to allow the monitor to move freely. Remove the safety bracket [B] only to adjust the swivel tension nut [C]. Be sure to replace the safety bracket after adjusting the swivel tension nut. The hex hole in the safety bracket must seat over the swivel tension nut. [. . . ] cSAV makes no representation of warranty , expressed or implied , regarding the information contained herein. CSAV assumes no responsibility for accuracy, completeness or sufficiency of the information contained in this document. [. . . ]