User manual SANUS VISIONMOUNT FLAT PANEL WALL MOUNT-VMPL

[. . . ] Please call Sanus Systems before returning products to the point of purchase. Do not use this product for any purpose that is not explicitly specified by Sanus Systems. If you do not understand these directions, or have any doubts about the safety of the installation, please contact Sanus at +31 -(0)40 26 68 619 or www. [. . . ] Replacement parts for products purchased through authorized dealers will be shipped directly to you. Check carefully to make sure that there are no missing or defective parts. sanus Systems can not be liable for damage or injury caused by incorrect mounting , incorrect assembly , or incorrect use. Please call Sanus Systems before returning products to the point of purchase. Step 1: Adjust the Pillar Clamp Height for Thicker Desk Surfaces (optional) CAuTION: Do not adjust the height of the Pillar with a monitor attached. Sanus Systems is not responsible for property damage and/or personal injury. If you have a thick desk surface, you may need to adjust the Pillar clamp height. Loosen and remove the two screws on the Pillar stem [A] with the Allen Key [D], as shown in Figure 1. Slide the two pieces of the stem apart until the upper holes on the outside stem align with the holes on the inner stem. Attach the Monitor Mount [B] to the back of your LCD monitor using the M4 x 10 mm Screws [E], as shown in Figure 3. Position the Monitor Mount so that the large side of the tapered hole faces the bottom of the monitor. Place the four screws through the Monitor Mount into the VESA bolt mounting pattern on the back of the monitor. Step 6: Cable Management Place the monitor cables into the channel on the back of the pillar [A]. Snap the cable cover [C] into the grooves along the edge of the channel, as shown in Figures 6a and 6b. Step 7: Adjust Pillar Height (Optional) CAuTION: Do not adjust the Pillar height if a monitor is attached. Sanus Systems is not responsible for property damage and/or personal injury. Remove the Cable Cover [C] from the Pillar [A], and lift the monitor cables out of the channel on the Pillar. See Step 5 for additional details about how the Monitor Mount and Pillar fit together. [. . . ] See Step 5 for additional details about how the Monitor Mount and Pillar fit together. Loosen the two screws at the top of the Pillar with a Phillips screwdriver. And its affiliated corporations and subsidiaries (collectively, "CSAV"), intend to make this manual accurate and complete. [. . . ]