User manual SANUS VISIONMOUNT FLAT PANEL WALL MOUNT-VMDD26

[. . . ] Sanus makes every effort to assure all necessary television mounting hardware is included. If the hardware you need is not included please consult your local hardware store or call Sanus Systems. Note: Wall must be capable of supporting 5 times the weight of the television plus the wall mount!Step 1: Mounting Monitor Brackets to a television with a Flat Back First, determine the diameter of the Bolt (p, q, r, s) your TV requires by hand threading them into the threaded insert on the back of the TV. [. . . ] Next, tighten a 1/4-20 Nut (m) onto the end of the 2" Carriage bolt. Step 4: Attach the Arm Assembly to the Television (Part I) First, orient each Vise Assembly (f) so that a 1" Diameter Tube (d) will pass through the 1" round hole in the Monitor Bracket (e) and then between the jaws of the Vise Assembly as shown in Diagram 4a. Insert a 1" Diameter Tube through the top hole in the first Monitor Bracket also shown in Diagram 4a. Warning: The 1" Diameter Tubes must extend beyond the outside edges of both Monitor Brackets and the Allen Bolts in all 4 Vise Assemblies in the Monitor Brackets and the 4 Vise Assemblies in the Arm Assembly must be tightened for the installation to be safe! position the Arm Assembly (b) so that the hook shaped tab shown in the Detailed View of Diagram 4b is on the top. Line up the two 1" diameter holes in the Monitor Bracket (e) at the other end of the Arm Assembly with the with the 1" Diameter Tubes (d). Continue to push the 1" Diameter Tubes through both the vise assemblies on the Arm Assembly and then through the other Monitor Bracket. Again, make sure the Vise Assemblies (f) on both the Arm Assembly and the second Monitor Bracket are oriented so that the 1" Diameter Tubes will pass between the jaws. Once the 1" Diameter Tubes are in place, tighten the allen bolts on the four Vise Assemblies in the two Monitor Brackets with the Allen Key (l) to lock the television to the mount. Next, slide the Arm Assembly into the desired position between the two Monitor Brackets and tighten the four remaining Allen Bolts in the Vise Assemblies inside the Arm Assembly. Tighten Lag Bolts (i) only until the Lag Bolt Washer (j) is pulled firmly against the Wall Plate (a). The Wall Plate (a) must be mounted to two wood studs at least 12" apart. It is a good idea to verify where the studs are located with an awl or thin nail. 5" deep hole in each stud at the desired height using a 3/16" drill bit. Make sure these holes are in the center area of the studs and level with each other. Use the Wall Plate as a template to mark the location of the second hole in each stud. 5" deep holes using the 3/16" drill bit in the marked locations. attach the Wall Plate to the wall using four Lag Bolts (i) and four Lag Bolt Washers (j). Make sure the Wall Plate is oriented so the flat surface in the center of the plate is against the wall. Step 6: Hang the assembly onto the Wall Plate Warning: This step may require 2 people to lift the assembly onto the Wall Plate! [. . . ] Proceed to tighten the Preventor Bolts with an Allen Key (k) until tight. Step 9: Wire Management Warning: Do not run Cables through a pinch point!Before beginning cable management pull the television into the position as far from the wall as possible. Leave some slack in the cables so that during motion so there is no added tension on the connectors. [. . . ]