User manual SANUS VISIONMOUNT COMPONENT BRACKET-VMBR

[. . . ] Assembly Instructions for Model: VMBR Thank you for purchasing a Vision Mount product. [. . . ] Place a 17 mm Wide Foam Pad (d) onto the vertical side of each Component Holder (c). Next, place a 15 mm Wide Foam Pad (e) onto the horizontal side of each Component Holder as shown in Diagram 1. a f c e Sanus Systems 2221 Hwy 36 West, Saint Paul, MN 55113 7. 22. 05 Customer Service: 800. 359. 5520. See complementary Sanus products at www. sanus. com Step 2: Add an Extension Arm (b) to each side of the Main Arm (a). Lock each Extension Arm into place at the desired width using a Set Screw (g). Step 3: A Component Holder (c) fits into the track on the inside of each Extension Arm (b). Insert a Knob (h) through the slot in the Extension Arm from the outside and thread it into the hole in each Component Holder as shown in Diagram 3 below. Diagram 2 g a b Diagram 3 b slot h c Step 4: Place the Mount Bracket (j) over the Arm of the TV wall mount. Place both 6 mm Diameter Bolts (k) down through the Mount Bracket so that the square neck of the bolts fit into the square holes in the bracket. [. . . ] Note: Adjust the bracket until the component is secured against the foam pads. Sanus Systems 2221 Hwy 36 West, Saint Paul, MN 55113 7. 22. 05 Customer Service: 800. 359. 5520. [. . . ]