User manual SANUS TELEVISION TURNTABLE-TV13TV20TV27TV32

[. . . ] Assembly Instructions for Television TurntablesTM TV13, TV20, TV27, TV32 Congratulations on your purchase! [. . . ] Supplied Parts: (1) Television Turntable Supplied Parts: (1) Self Adhesive Protective Feet (pad of 4) Step 1: Position the Turntable so the black nylon swivel is facing up. Next, place a Adhesive Foot inside each circle, as shown in Diagram 1. NOTE: If you are going to use the optional TV-VCR Kit, Proceed to the instructions for those at the bottom of the page, otherwise, proceed to Step 2. Step 2: Flip the Turntable over and place it in the desired position on a shelf or cabinet so the Adhesive Feet are facing down and are in direct contact with the shelf or cabinet as shown in Diagram 2. Adhesive Foot Diagram 1 Circle Bottom of Turntable Diagram 2 Top of Turntable Assembly Instructions for Optional TV-VCR Kit* * TV-VCR Kit will not work with the TV13 Turntable TV Turntable (sold separate) Contents: (1) Base Contents: (2) Support Pillars Contents: (4) Plastic Dowels Contents: (4) Allen bolts Contents: (1) Allen Wrench Support Pillar Support Pillar Base Sanus Systems 2221 Highway 36 W. Paul, MN 55113 800. 359. 5520 www. sanus. com 7. 6. 04 Step 1: Remove the swivel from the TV Turntable by removing the Phillips Screw in the center of the swivel as shown in the Diagram to the right. Phillips Screw Bottom of Turntable Step 2: Use the same Phillips Screw removed from Step 1 to fasten the swivel to the base of the TV-VCR Kit. Insert the Phillips screw through the center hole of the swivel and proceed to thread it into the appropriate pilot hole in the center of the TV-VCR Kit as shown in the Diagram on the right. Step 3: Insert the Plastic Dowels into the larger holes in the Support Pillar as shown in the Diagram on the right. [. . . ] Paul, MN 55113 800. 359. 5520 www. sanus. com 7. 6. 04 Nylon Swivel is Located on the Bottom Top of TV Turntable Plastic Dowel Front of Assembly [. . . ]