User manual SANUS STEEL FOUNDATIONS-SFC18 SFC22

[. . . ] 4] The Steel Foundations center channel stand has included a pair of adjustable studs (j) and 1/4" rubber stud covers (k). Thread the adjustable stud through the top plate with the allen wrench to the desired height. [. . . ] We can assist with questions or damaged/ Sanus Systems 2221 Highway 36 W St. Paul MN 55113 11. 22. 04 800. 359. 5520 www. sanus. com STEEL FOUNDATIONS® SFC INSTRUCTION MANUAL Page 4 Page 1 Take the time to find the right speaker locations for your listening room. 1] Attach the plastic feet (e) to the corners of the base with the small pan head bolts (f). Align the holes in the base with the holes in the isolation block (a). Bolt the pillars and the base together with the isolation block between them using the large pan head bolts (b) and lock washers (c). Photo 3-Using the wire guide is optional. PHOTO 1 d a h f k g n i j b Photo 2 c 2] Adhere the two inch self-adhesive damping washers (l) to the flush side of each top plate. The damping washers will be set in between the top plate and the pillars. (Optional: You may fill the pillars with sand or shot at this time. ) Align the holes in the top plate with corresponding holes in the top of each pillar. Bolt the pillars and the top plate together using the flat head bolts(n). 3] Both spiked feet (g) and rubber feet (d) are provided for your Steel Foundations®. [. . . ] Before installing, be sure to check that the feet are mounted with the (1) foot on the front left and rear right of the base, (2) front right and rear left. The designation (1) & (2) are on the bottom of each foot. Page 2 (PHOTO 1) a) isolation block - 1 b) 1-1/2" pan head bolt - 2 c) lock washer - 2 d) rubber isolation pad - 8 e) plastic foot - 4 f) 5/8" pan head bolt - 4 g) carpet spike - 4 h) machine nut - 8 i) allen key - 1 j) threaded stud - 2 k) rubber stud cover - 2 l) cork damping washer - 2 m) wire guide - 2 n) flat head bolt - 2 Page 3 * PLEASE READ THE NOTE ON PAGE 4 OF THIS MANUAL! [. . . ]