User manual SANUS NATURAL FURNITURE PLASMA MOUNT ADD-ON FOR NF203 NF213-NFPM

[. . . ] Step 2 INSTRUCTIONS FOR NFPM PLASMA MOUNT Long Vertical Rails (2) 3" Tubes (8) Plastic Washers ­ small holes (12) 4. 5" Bolts (4) Allen Wrench (1) Short Horizontal Rails (2) Metal Washers (8) Plastic Washers ­ large holes (4) 2. 5" Bolts (4) Edge Guard (2) Step 2 1] This product works with Sanus NF203 and NF213 Television stands. [. . . ] The 4. 5" Bolts will actually thread in to the middle Cross Tubes of the Natural Furniture. 3] Notice that the ShoryHorizontal Rails have threaded inserts attached to them. The outside inserts are used for the NF213 and the inside inserts are used on the NF203. Each Horizontal Rail mounts using two 3" Steel Tubes with a Plastic Washer positioned on each end of the Tube. Use the Plastic Washers with the larger holes on the side of the 3" Tube that faces the Horizontal Rail; use the Plastic Washers with the smaller holes on the side that faces the Vertical Rail. Put a Small Steel Washer over each 2. 5" Bolt; slide the bolt through the Vertical Rail, through the 3" Tube into the threaded inserts in the Horizontal Rail. Once the required height of each Horizontal Rail is determined, tighten firmly. 4] Consult your Hardware or AV Profesional to mount the Plasma Television to the Horizontal Rails. [. . . ] A washer should be used over the chosen bolt head to prevent it from pulling through the slots in the Horizontal Rails. Step 3 Sanus Systems 2221 Hwy 36 West, Saint Paul, MN 55113 11. 19. 04 Customer Service: 800. 359. 5520. [. . . ]