User manual SANUS NATURAL FURNITURE MEDIA TOWER-NFCDII

[. . . ] Assembly Instructions for Model: NFCDII Thank you for choosing a Sanus Systems Natural Media Tower. The Model NFCDII is designed to keep your collection clean and organized by storing up to 430 CDs or 230 DVDs, all in one convenient location. If you do not understand these directions, please contact Sanus at 800. 359. 5520 or www. sanus. com. [. . . ] 2 Step 1 - Insert Decorative Face Bolts into Front Leg Insert the Decorative Face Bolts (O) into the Front Leg (D) making sure they are flush with the Front leg. If necessary, the rubber mallet may be used to lightly tap them into place. Diagram 1 D O Step 2 - Secure Steel Tube to Front Leg Lay the Front Leg (D) face down on a soft surface with the threads of the Decorative Face Bolts (O) facing up; then, place a Washer (Q) over the middle Decorative Face Bolt, and thread the Steel Tube (G) onto it. Diagram 2 Q D G Step 3 - Secure Front Leg to NFCDII Base Attach the Front Leg (D) to the NFCDII Base (B) by inserting the two outer Decorative Face Bolts (O) through the two holes of the NCFDII Base and securing with two Nuts (P). Diagram 3 D O P B O P Step 4 - Secure Back Leg to Tube and NFCDII Base Place a Washer (Q) between the Tube (G) and the Back Leg (C); then, using an Allen Bolt (N) secure the Back Leg to the Tube. Using the two Allen Screws (S), secure the Back Leg (C) to the NFCDII Base (B). Diagram 4 S B G N Q C Step 5 - Insert Cam Pins into Side Panels There are two holes that are centered on each side of the Side Panels (F), and 12" [304. 3 mm] from each end. Using the phillips screwdriver, screw Cam Pins (K) into the two holes of each Side Panel taking care not to over tighten the Cam Pins. Diagram 5 F K F Step 6 - Insert Cam into Center Support. Place a Cam (J) into each of the four holes in the Center Support (E). Using a phillips screwdriver align each Cam so the arrow is pointing toward the small hole on the edge of the Center Support (See Detail - A). Diagram 6 Cam Hole E Cam - J Cam - J Small Hole Small Hole Detail - A Step 7 - Secure Side Panels to Center Support. The Cam Pins (K) installed in each Side Panel (F) line up with the small holes in the edge of the Center Support (E). The top of each Side Panel is smooth and the bottom has a notch routed in the inside edge. Attach a Side Panel to each side of the Center Support and using a phillips screwdriver, rotate each Cam (J) one-third turn clockwise until secure (See Detail - B). [. . . ] Diagram 9 M M B F F Step 10 - Installing Glass Shelves Turn the assembly over. Place the Shelf Pins (R) in to holes in the Side Panels (F) where you want the Glass Shelves (H) to be located. Diagram 10 R H Step 11 - Attach Name Plate Attach the Sanus Name Plate (I) to the desired location. Diagram 11 I Sanus Systems 2221 Hwy 36 West, Saint Paul, MN 55113 02. 28. 06 (100011) Customer Service: 800. 359. 5520. [. . . ]