User manual SANUS NATURAL FURNITURE AV STANDS-NF206

[. . . ] Assembly Instructions for Natural Furniture: Model NF206 Thank you for choosing the Natural Furniture line from Sanus Systems. [. . . ] Slide a Three Hole Plate (J) over the Decorative Face Bolts; then, screw a Cross Tube (E) onto each Decorative Face Bolt, firmly hand tighten each Cross Tube. Diagram 1 A J E N Step 2: Attach Cross Tubes W/Stud to Front Frame Place a 1 inch Washer (L) on the threaded stud of each Cross tube W/Stud (F) and screw them into the Front Frame (A). Diagram 2 A L F Step 3: Attach Rear Frame to Front Frame and Cross Tubes With The Cross Tubes still facing up, and the Front Frame (A) still on a soft, flat surface. Place a 1 inch Washer (L) on each Cross tube W/Stud (F) and a Three Hole Plate (J) on the remaining Cross Tubes (E). NOTE: Horizontal grooves in the Rear Frame must be facing the Front Frame and the three holes closest to the edge of the Rear Frame must be aligned toward the top of the Front Frame. Align the holes in the Rear Frame (B) with the holes in the Cross Tubes; then, using a 1. 5 inch Washer (O) and Allen Bolt (K), secure the Rear Frame to the Cross Tubes W/Studs (F) using the Allen Key (M). Using 1. 5 inch Washer (O) and Allen Bolt (K), secure the Rear Frames to the two center Cross Tubes (E) using the Allen Key (M). Using Allen Bolts (K) and Allen Key (M), secure the two Wire Straps (I) to the Rear Frame. [. . . ] Diagram 6 I H Plastic Wire Cover Grooves in Rear Frame (B) Top View G I B Sanus Systems 2221 Hwy 36 West. [. . . ]