User manual SANUS NATURAL FOUNDATIONS 18QUOT CENTER CHANNEL SPEAKER STAND-NFC18

[. . . ] Damaged or missing parts can be quickly obtained by contacting Sanus Customer Service at (800) 359-5520 or www. sanus. com. The speaker cable hole in the base and the bolt mounting hole in the top plate should be to the rear of the pillar. [. . . ] Thread a nut on to the end of each spike, and thread the spikes into the holes in the base of the stand. The plastic feet may be attached to the base with the 5/8" pan head bolts. Optionally, the spiked feet and plastic feet may be used together by threading the nut all the way down the spike and attaching the plastic foot with the spike. A 7/16" socket is recommended to tighten the nut securely against the plastic foot. 6] The extra holes in the top plate may be used to attach speakers that accomodate bottom bolt mounting. If you are using the adjustable spikes, make sure they are level and that the stand does not rock. Set the speaker on the stand and run the speaker wire down the back of the pillar and through the hole in the base. Slide the covers down until they touch the base. *NOTE: The end of the spikes and the studs are sharp and may scratch floors or furniture. For this reason rubber pads and plastic feet are provided as an option. The decision to use steel spiked feet and speaker studs is yours; Sanus Systems is not liable for damage or injury. INSTRUCTION MANUAL FOR Base Plate a] Pillar b] Wood Base Plate c] Plastic Foot NATURAL FOUNDATIONS® The job of the speaker stand is to raise the loudspeaker to ear height. When this is done correctly, most aspects of the listening experience benefit. Bass is tighter, mids and highs are clearer, and imaging detail improves. [. . . ] The easiest way to find the optimum speaker locations is with b educated trial and error. Your Sanus trained audio consultant can get you started in the right direction, but in the end you need to trust your ears. [. . . ]