User manual SANUS MINI SYSTEM BLACKSILVER STAND-AFMINI II

[. . . ] Assembly Instructions for Model: AFMini Thank you for choosing the Sanus Systems Model AFMini. Every effort has been made to ensure that your Sanus Systems furniture is perfect. [. . . ] See complementary Sanus products at www. sanus. com Step 1 - Threaded Rod into Base Thread the four Threaded Rods (D) into the metal inserts in the Base (H). Diagram 1 D D H H Step 2 - Slide Plastic Disk and Short Pillars over Threaded Rods Slide a Plastic Disk (J) with its flat side facing down over each Threaded Rod (D). Slide a Short Pillar (A) over each Threaded Rod (D) so that it is seated in the Plastic Disk (J). Slide another Plastic Disk (J) with its flat side facing up over each Threaded Rod (D) so that it seats on top of each Short Pillar (A). Diagram 2 J A D J Step 3 - Install Speaker Shelves NOTE: Make sure the rounded edges of the two Speaker shelves (G & I) are facing down and the square edges are towards the rear. Slide the Right Speaker Shelf (I) over two Threaded Rods (D) so that the hole for the CD Rod is towards the center of the AFMini. Slide the Left Speaker Shelf (G) over two Threaded Rods (D) so that the hole for the CD Rod is directly opposite the CD Rod hole on the Right Speaker Shelf (I). Use a book, tissue box, or VHS tape to support the Right and Left Speaker Shelves (I & G) and keep them from drooping. Diagram 3 I D CD Rod hole I G Step 4 - Slide Plastic Disk, Front Pillars, and Rear Pillars over Threaded Rods Slide a Plastic Disk (J) with its flat side facing down over each Threaded Rod (D). NOTE: The Front and Rear Pillars (B & C) are distinguishable by the fact that the 1/4 [6. 4 mm] hole for the CD Rods in each Front Pillar (B) is 3. 5 [88. 9 mm] from the end and the hole in each Rear Pillar (C) is 4 101. 6 mm] from the end. Slide a Front Pillar (B) over the two front Threaded Rods (D), so they are seated in the Plastic Disk (J). Slide a Rear Pillar (C) over the two rear Threaded Rods (D), so they are seated in the Plastic Disk (J). [. . . ] Remove the backing material from the four Rubber Feet (K) to expose the adhesive on them; then, attach a Rubber Foot to each corner of the Base (H) as shown in Diagram 6B. Diagram 6A Diagram 6B L K H K C B H D C B L Sanus Systems 2221 Hwy 36 West, Saint Paul, MN 55113 2. 13. 06 (100002) Customer Service: 800. 359. 5520. [. . . ]