User manual SANUS JAVA FURNITURE-JFV65

[. . . ] Check carefully to make sure none of the parts are missing or defective. Replacement parts for products purchased from an authorized dealer will be shipped directly to you. Required Tools: Phillips Screw Driver Note: Check carefully to make sure you have all the hardware listed below. [. . . ] Proceed to tighten the Cams on each Outside Panel in a clockwise motion. Detailed View Diagram 2 channel c b a o channel Note: Cams should be tightened in a clockwise motion Step 3: Add Inside Panels Insert each Cam (a) into each Inside Panel (q, r) in the same manner as you did in Step 2. Place the Inside Panel so that it fits over the Dowels (c) and Cam Pins (b) as shown in the Detailed View of Diagram 3. Detailed View r o b c a Diagram 3 Note: Cams should be tightened in a clockwise motion Step 4: Add Dowels Insert 8 Dowels (c) into the top of Panels (q, r, s, t) as shown in the Detailed View of Diagram 4. Detailed View c Diagram 4 t s q r t Step 5: Add Barrel Nut and Bolt Place the Bottom (p), with track and channel facing up on a soft surface, which will help prevent scratching. Next, orient the Barrel Nut (d) so the hole in its side faces the hole in the back of the Top. Proceed to insert the Barrel Nut into the hole as shown in the Detail View of Diagram 5. Then thread the Barrel Nut Bolt (e) into the hole on the back of the Bottom, as pictured in Diagram 5. Tighten each Barrel Nut Bolt so that they protrude a 1/4" From the Top. Detailed View d e Diagram 5 channel p track Step 6: Add Bottom Flip the Bottom (p) so the track and channel are facing down. Align the bottom piece so it is resting on the Panels (q, r, s, t) with the 4 large holes toward the back as shown in Diagram 6. Insert a Base Bolt (l) through the Bottom and into the appropriate hole in the Panel. Detailed View Diagram 6 l p Step 7: Prepare Bottom Insert 6 Cam Pins (b) and 6 Dowels (c) into the Bottom (p) as shown in the Detailed View of Diagram 7. Tighten all Cam Pins with a Phillips screw driver until they are tight. Detailed View Diagram 7 c b p Step 8: Assemble Base Insert 4 Cam Pins (b), 4 Dowels (c), and 10 Cams (a) as shown in Diagram 8. Once assembled, the rails should form a solid rectangle. c x Diagram 8 w a b Note: Cams should be tightened in a clockwise motion Step 9: Add Base Assembly to Bottom Flip and align the assembled base frame so the holes in the assembled base frame line up with the Dowels (c) and Cam Pins (b) on the Bottom (p). Proceed to tighten all 6 of the Cams (a) on the Front Base Rails (w) that correspond with the Cam Pins on the Bottom so that the assembled base frame is secured to the Bottom. Diagram 9 a p b w c Note: Cams should be tightened in a clockwise motion Step 10: Add Legs To add the Legs (y) first slide the Rubber Spacer (g) so it fits into the Aluminum Spacer (h). [. . . ] Make sure the left and right Back Panel slide into the channel in the Outside Panels. Diagram 13 aa Step 14: Add Doors Add 2 Door Protectors (k) to each side of the door as shown in the detailed View of Diagram 14. Then, insert the Door so that the pegs on the top of the door are inserted into the Channel in the Top (o) and the bottom wheels fit on the Track on the Bottom (p) as shown in Diagram 14. [. . . ]