User manual SANUS EURO FOUNDATIONS-EF20B EF24B EF28B

[. . . ] Assembly Instructions for Euro Foundations: EF20, EF24, EF28 Thank you for choosing Euro Foundations from Sanus Systems. The goal of these speaker stands is to improve the listening experience, by raising the speaker to the correct height, and isolating the speaker from resonance effects. [. . . ] Check carefully to make sure that there are no missing or defective parts. Our customer service representatives can quickly assist you with installation questions and missing or damaged parts. Replacement parts for products purchased through authorized dealers will be shipped directly to you. Do not use this product for any purpose that is not explicitly specified by Sanus Systems. Sanus Systems can not be liable for damage or injury caused by incorrect assembly, or incorrect use. Please call Sanus Systems before returning products to the point of purchase. Required Tools: Phillips screwdriver Supplied Parts and Hardware: Some parts not shown as actual size* a - Flat Head Top Plate Bolt (2) b - Pan Head Base Bolt (2) c - Carpet Spike (6) m - Speaker Bolt (2) d - Rubber Isolation Feet (8) e - Lock Washer (2) f - Neoprene Speaker Pads (8) g - Spike Lock Nuts (6) h - Top Plate - 6" x 6. 5" (2)* i - Base (2)* j - Cork Damping Ring (2)* k - Pillar (2)* l - Top Plate - 5" x 5" (2)* Note: Included with EF28 model only Sanus Systems 2221 Hwy 36 West, Saint Paul, MN 55113 9. 14. 05 Customer Service: 800. 359. 5520. See complementary Sanus products at www. sanus. com Step 1: Attach Pillars to Base Locate the Base (i), Pan Head Base Bolt (b), and Lock Washer (e). Position the Pillar so that the wire management holes face the back leg of the Base. See Diagram 1 for assistance. Diagram 1 k i e b Step 2: Attach Top Plate Locate the Top Plate (h), Cork Damping Ring (j), and Flat Head Top Plate Bolt (a). Peel the backing from the Cork Damping Ring, and stick against the bottom side of the Top Plate, aligning it with the center hole of the Top Plate. Thread the Flat Head Top Plate Bolt through the aligned holes, into the top end of the Pillar (k). [. . . ] Thread the Carpet spikes into the threaded holes on the underside of the Base (i). Adjust the Carpet Spikes so that the stand is level, and tighten the Spike Lock Nuts against the Base. [. . . ]