User manual SANUS COMPONENT FURNITURE VIDEO LOWBOY-CFV47CB

[. . . ] Our customer service representatives can quickly assist you with missing or damaged parts. Replacement parts for Sanus products purchased through authorized dealers can be shipped directly to you. Please call Sanus Systems before returning products to the point of purchase. Required Tools: Phillips screw driver Note: Check carefully to make sure all of the parts and hardware are accounted for. [. . . ] Once you have the Front Rails aligned so the bottom one is resting on the Foot (n), and the top one is level with the corner pillar, tighten the allen bolt in the back of the Front Rail to widen the clamp to secure it to the pillar. Top View (Front Right Corner) Diagram 3 allen bolt y w clamp Step 4: Attach the Back Rails Attach the Cam Pins (b) to the Back Rail (x). Make sure the arrow on each Cam is facing the hole in the outside of the Back Rail and add two Cam Pins to each end of the Back Rail as shown in the Detailed View of Diagram 4. Insert the Cam Pins until there is a small space between the head of the pin and the Back Rail. Attach the Back Rail by sliding the cam pins down the groove on the Side Panel pillar as shown in the Top View of Diagram 4. Make sure the bottom Back Rail is oriented so the threaded holes near the ends are on the top, and the Cams face inside the cabinet, as seen in Diagram 4. Make sure the top Back Rail is oriented so the threaded holes near the ends are on the bottom, and the Cams face inside the cabinet, as seen in Diagram 4. Once the Back Rail is resting on the Foot (p), tighten the cams labeled in Diagram 4 to hold it in place. Diagram 4 Detailed View Top View (back left corner) b cam b y x x Step 5: Add the Back Panel Insert a Back Panel Bolt (d) through the Back Panel (z), a Spacer (c) and thread it into the Back Rail (x) as seen in the Detailed View of Diagram 5. Repeat the process until all 8 Back Panel Bolts are attached to the Back Rails. Note: Position of Top Back Rail may need to be adjusted for the Back Panel to fit properly. Diagram 5 Detailed View x c d z Step 6: Add Bottom Shelf Bracket Thread a Phillips Pan Head Bolt (e) though each hole in the Bottom Shelf Bracket (p), and into the Back Rail (x) as seen in the Detailed View of Diagram 6. Diagram 6 Detailed View x e p Step 7: Add Bottom Shelf Thread a Bottom Shelf Pin (h) into the Side Panel (y) as shown in the Detailed View of Diagram 7. Repeat process until all four Bottom Shelf Pins have been inserted into the Side Panel. Proceed to press fit the Bottom Shelf (u) so it is locked into the Bottom Shelf Pins. Detailed View Diagram 7 y h u Step 8: Attach Brackets to Bottom Shelf Gently rotate the cabinet so it is resting on its back. Thread a Wood Screw (i) through each hole in the Bottom Shelf Retainer (o) and into the Bottom Shelf (u) as seen in Detailed View A of Diagram 8. Next, Thread a Wood Screw through each hole in the Bottom Shelf Bracket (p) and into the Bottom Shelf as seen in Detailed View B of Diagram 8. [. . . ] The slot on the end of the Hinge will fit around the bolt on the Hinge Plate. The top and bottom Hinges should engage at the same time as shown in Diagram 12. Once the two parts of the Hinge are mated, tighten the bolt on the Hinge Plate firmly with a screwdriver. [. . . ]