User manual SANUS SYSTEMS SFV49

[. . . ] Next, place a Glass protector on the back of each Lower Brace Bars (f). [. . . ] Then, evenly place 4 Glass protectors on the top of the Back Frame (b). Next, place the Top Glass Shelf (c) on the top of the Front and Back Frame. Finally, place the Glass Shelf (d) so it rests on the Lower Brace Bars and the crossbar on the Front Frame. Detailed View Thank you for choosing the Steel Furniture line from Sanus Systems. Paul, MN 55113 800. 359. 5520 www. sanus. com 7. 21. 04 Hardware: Shown at actual size Step 2: Attach Brace Bars to Front Frame Thread a Short Allen Bolt (g) through each hole in the Upper Brace Bar (e) until the bar is secured to the Front Frame (a). Proceed to thread a Short Allen Bolt through each hole in the Lower Brace Bars (f) so each bar is secured to the Front Frame. Do not fully tighten the Short Allen Bolts at this time. (6) Short Allen Bolt - g (3) Long Allen Bolt - h (3) Washer - i Diagram 2 Detailed View A (4) Foot - j Step 1: Install Feet (13) Glass Protector - k Allen Key - l Detailed View B a e g Thread 2 Feet (j) into the bottom of the Front Frame (a) as shown in Diagram 1. Note: Once the stand is assembled, the Feet can be adjusted to level the stand if needed a f g Diagram 1 Step 3: Attach Back Frame Thread a Long Allen Bolt (h) through a Washer (i), the Back Frame (b), and into the back of the Brace Bar (e, f) as seen in Diagram 3. [. . . ] Note: Once the stand is assembled, the Feet can be adjusted to level the stand if needed a f g Diagram 1 Step 3: Attach Back Frame Thread a Long Allen Bolt (h) through a Washer (i), the Back Frame (b), and into the back of the Brace Bar (e, f) as seen in Diagram 3. [. . . ]