User manual SANUS SYSTEMS BFAV550

[. . . ] Check carefully to make sure that there are no missing or defective parts. Our customer service representatives can quickly assist you with installation questions and missing or damaged parts. Replacement parts for products purchased through authorized dealers will be shipped directly to you. [. . . ] Replacement parts for products purchased through authorized dealers will be shipped directly to you. Do not use this product for any purpose that is not explicitly specified by Sanus Systems. Sanus Systems can not be liable for damage or injury caused by incorrect mounting, incorrect assembly, or incorrect use. Please call Sanus Systems before returning products to the point of purchase. Required Tools: Phillips screw driver, drill, 1/4 inch drill bit Supplied Parts and Hardware: Some parts not shown as actual size* (3) T - Nuts - b (1) Mount Assembly - a (3) 10-24 x 5/8 Bolt - c (4) M4 x 10 mm Bolt - d (4) M4 x 20 mm Bolt - e (4) . 5 inch Spacer - f (4) Cable Tie - g (1) Allen Key - h Sanus Systems 2221 Hwy 36 West, Saint Paul, MN 55113 1. 3. 05 Customer Service: 800. 359. 5520. See complementary Sanus products at www. sanus. com Step 1: Remove Cover Using a Phillips screw driver loosen the two flat head bolts from the cover and slide it down and away from the mounting plate. You will re-install the cover once cable management is complete. Diagram 1 a mounting plate cover flat head bolts Step 2: Prepare Mounting Surface Use the base of the Mount Assembly (a) as a template to mark three holes in the cabinet in the desired location. Note: You will re-install the cable cover once cable management is completed. Diagram 7 Detailed View cable cover screw Step 8: Cable Management (±35° swivel) If ±110° swivel is desired, skip to Step 9. You can attach the Cable Ties (g) in locations marked in Diagram 8 below. Re-install the cable cover and the base cover in the same manner they were removed. Diagram 8 a cable path cable tie holder Step 9: Remove Degree Stop Using provided Allen Wrench (h), remove the 35 degree stop. Diagram 9 35 degree stop Step 10: Cable management (±110°) Swivel the Mount Assembly (a) 110° either left or right. Cables must be wrapped a complete 360° inside the base of the Mount Assembly. [. . . ] Diagram 9 35 degree stop Step 10: Cable management (±110°) Swivel the Mount Assembly (a) 110° either left or right. Cables must be wrapped a complete 360° inside the base of the Mount Assembly. You can attach the Cable Ties (g) in locations marked in Diagram 8 below. [. . . ]