User manual SANT ANDREA MILLENNIUM E ELEC SCHEMA

[. . . ] The appliance must be installed by a qualified professional according to the instructions provided. Any necessary adjustment or maintenance must be performed after the appliance has been disconnected from the electricity supply. The legs* provided with the appliance fit into the slots on the underside of the base of the cooker. GB Electrical connection Electric cookers come without a power supply cable. The cooker is designed to operate on an electricity supply which conforms to the electrical data shown on the Rating Plate. [. . . ] Oven light This is switched on by turning the SELECTOR knob to any position other than “0”. By selecting with the knob, the light is switched on without any of the heating elements being activated. Cooling ventilation* In order to cool down the external temperature of the oven, some models are fitted with a cooling fan that blows out air between the control panel and the oven door. Once the cooking has been completed, the cooling fan remains on until the oven has cooled down sufficiently. GB Starting the oven 1. See the Cooking advice table for cooking modes and the suggested cooking temperatures (see Cooking Modes). When preheating is finished, the THERMOSTAT indicator light will stay on: place the food in the oven. You may do the following during cooking: - change the cooking mode by turning the SELECTOR knob. - stop cooking by turning the SELECTOR knob to the “0” position. Never put objects directly on the oven bottom to avoid damaging the enamel coating. When the SELECTOR knob is turned in a clockwise direction to the symbol the fan and oven light will come on to assist in the defrosting of frozen food. Rotating further to the complete range of temperatures shown on the dial you can choose which is most suitable for the food you are going to cook (fan assisted mode). The residual heat indicator light: this indicates that the A A temperature of the corresponding cooking zone B is greater than 60°C, even when the heating element has been switched off but is still hot. Cooking zones with heating elements The radiant heating elements are composed of circular heating elements. Turn the corresponding knob in a clockwise direction, to a position between 1 and 6. Practical advice on using the hob • Use pans with a thick, flat base to ensure that they adhere perfectly to the cooking zone. • Always use pans with a diameter that is large enough to cover the hotplate fully, in order to use all the heat produced. • Always make sure that the base of the pan is completely clean and dry: this ensures that the pans adhere perfectly to the cooking zones and that both the pans and the hob last for a longer period of time. • Avoid using the same cookware that is used on gas burners: the heat concentration on gas burners may have warped the base of the pan, causing it not to adhere to the surface correctly. • Never leave a cooking zone switched on without a pan on top of it, as doing so may cause the zone to become damaged. 8 Precautions and tips !This appliance has been designed and manufactured in compliance with international safety standards. The following warnings are provided for safety reasons and must be read carefully. • The glass ceramic hob is resistant to mechanical shocks, but it may crack (or even break) if hit with a sharp object such as a tool. If this happens, disconnect the appliance from the electricity mains immediately and contact a Service Centre. • If the surface of the hob is cracked, switch off the appliance to prevent electric shocks from occurring. • Always use oven gloves when placing cookware in the oven or when removing it. [. . . ] The crossed-out dustbin is marked on all products to remind the owner of their obligations regarding separated waste collection. Exhausted appliances may be collected by the public waste collection service, taken to suitable collection areas in the area or, if permitted by current national legislation, they may be returned to the dealers as part of an exchange deal for a new equivalent product. All major manufacturers of household appliances participate in the creation and organisation of systems for the collection and disposal of old and disused appliances. Respecting and conserving the environment • You can help to reduce the peak load of the electricity supply network companies by using the oven in the hours between late afternoon and the early hours of the morning. • Check the door seals regularly and wipe them clean to ensure they are free of debris so that they adhere properly to the door, thus avoiding heat dispersion. 9 Care and maintenance Switching the appliance off Disconnect your appliance from the electricity supply before carrying out any work on it. GB ! [. . . ]