User manual SAMSUNG NK36M7070VB

[. . . ] Read the instructions carefully: there is important information about installation, Do not carry out electrical or mechanical variations on the product or on the Before proceeding with the installation of the appliance verify that there are no damaged all components. Otherwise contact your dealer and do not proceed with the installation. Before any cleaning or maintenance operation, disconnect hood from the mains by removing the plug or disconnecting the mains electrical supply. Always wear work gloves for all installation and maintenance operations. [. . . ] Failure to install the screws or fixing device in accordance with these instructions may result in electrical hazards. Do not use with a programmer, timer, separate remote control system or any other device that switches on automatically. This appliance is marked according to the European directive 2012/19/EC on Waste Electrical and Electronic Equipment (WEEE). By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. On the product, or on the documents accompanying the product, Indicates that this appliance may not be treated as household waste. Instead it should Be taken to the appropriate collection point for the recycling of electrical and electronic Disposal must be carried out in accordance with local environmental For further detailed information regarding the process, collection and recycling of this Product, please contact the appropriate department of your local authorities or the local Department for household waste or the shop where you purchased this product. Suggestions for a correct use in order to reduce the environmental impact: Switch ON the hood at minimum speed when you start cooking and kept it running for few minutes after cooking is finished. Increase the speed only in case of large amount of smoke and vapor and use boost speed(s) only in extreme situations. Replace the charcoal filter(s) when necessary to maintain a good odor reduction efficiency. Clean the grease filter(s) when necessary to maintain a good grease filter efficiency. Use the maximum diameter of the ducting system indicated in this manual to optimize efficiency and minimize noise. The hood is conceived for the suction of cooking fumes and steam and is destined only for domestic use. The hood is designed to be used either for exhausting or filter version. In this case the fumes are conveyed outside of the building by means of a special pipe connected with the connection ring located on top of the hood. Diameter of the exhausting pipe must be equal to that of the connection ring. If the hood is supplied with active charcoal filter, then it must be removed. Connect the hood and discharge holes on the walls with a diameter equivalent to the air Using the tubes and discharge holes on walls with smaller dimensions will cause a diminution of the suction performance and a drastic increase in noise. Use a duct with as few elbows as possible (maximum elbow angle: 90°). filtration version The aspirated air will be degreased and deodorised before being fed back into the room. In order to use the hood in this version, you have to install a system of additional filtering based on activated charcoal. installation The minimum distance between the supporting surface for the cooking equipment on the hob and the lowest part of the range hood must be not less than 45cm from electric cookers and 50cm from gas or mixed cookers. If the instructions for installation for the gas hob specify a greater distance, this must be adhered to. [. . . ] Motor ON/OFF Press the T1 button and the hood will be activated at default speed (Default Speed : Low). Low speed Press the T2 button and the hood will be activated at Low speed. Med Speed Press the T3 button and the hood will be activated at Medium speed. High Speed Press the T4 button and the hood will be activated at High speed t5. [. . . ]