User manual SAMSON STUDIO GT V1.1

[. . . ] DO NOT USE THIS PLUG WITH AN EXTENSION CORD, RECEPTACLE OR OTHER OUTLET UNLESS THE BLADES CAN BE FULLY INSERTED TO PREVENT BLADE EXPOSURE. TO PREVENT FIRE OR SHOCK HAZARD. TO PREVENT ELECTRICAL SHOCK, MATCH WIDE BLADE PLUG TO WIDE SLOT AND FULLY INSERT. CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). This lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. [. . . ] Input Gain Level Knob (GAIN) - Controls the input level of the associated Mic/Inst input (6). Microphone/Instrument Inputs (Channel 1 & Channel 2) - Each XLR / ¼" combo connector will accept a standard mic, line or instrument level signal. Phones Level - Controls the overall output level to the left HEADPHONE output (7). 7 8 9 9. 10 11 2. 3. STEREO/MONO Button - This button allows you to select the direct input monitoring between stereo and mono operation. In Mono mode, the input signals will be heard equally in the left and right side of the Studio GT. In Stereo mode, Channel 1 will be heard in the left and Channel 2 will be heard in the right. 12 4. 5. 6. 10. MIX Control - The MIX control is used to balance the audio mix of the input signals and the audio coming from the computer. When turned fully counterclockwise, only the signals connected to the Studio GT inputs are heard. When turned fully clockwise, only the output signal from your computer is heard at the speaker and headphone outputs. Any adjustment between the two endpoints will result in a proportional mix of both the Studio GT inputs and computer audio. The monitors automatically mute when the right headphone is connected. Level Control - Controls the overall output level for both speakers and the right HEADPHONE output (11). 7. 8. 3 Studio GT Owner's Manual STUDIO GT REAR PANEL LAYOUT 1 2 3 7 4 5 6 8 1. 1/8" AUX INPUT ­ 3. 5mm stereo input jack for connecting a second line level signal source, like an MP3 player. RCA INPUT ­ Used to connect signals from unbalanced, ­10dBV devices, like a mixer. The Red connector is for the Right input and the White is for the Left input. USB Connector ­ Connect the supplied USB cable to this rear panel USB "B" connector. LEFT SPEAKER OUTPUT ­ Push Terminals for connecting the Left-side Extension Speaker. When set to the ON position, the front panel green LED illuminates indicating the Studio GT is powered up and ready for operation. TERMINAL CUP ­ Push Terminals for connecting the Left-side Extension Speaker to the Active (Right-side) speaker. TUNED PORT - Quiet port design offering linear extended low frequency response. Studio GT Owner's Manual 4 STUDIO GT QUICK START STUDIO GT HOOK-UP 1. Be sure to save the packaging in case you ever move or need to send the units for service. 2. Set the Studio GT monitors in place near your computer or multi media center. [. . . ] You can use a free program like ASIO4ALL, which is a hardware independent low latency ASIO driver for WDM audio devices. Use the following steps to utilize this tool: Go to http://www. asio4all. com and download the latest available version of ASIO4ALL. Install the software, and restart your computer if instructed to by the installer. In Sonar LE, for instance, go to Options Menu>Audio>Advanced tab and set the Driver Mode to ASIO and press APPLY. [. . . ]