User manual SAITEK ST50

[. . . ] The ST50 was designed for IBM PC and compatible systems, and will work with Windows ® 95/ 98/Millennium-based games. As shown under Features and Controls, this joystick boasts a thumb-controlled fire button, conveniently located at the top of the grip, plus a fast-reacting and easily-accessible finger trigger. You'll also appreciate the smooth and fluid operation of the built-in throttle. [. . . ] The joystick cursor should move in all directions, and the button indicators should turn on when the button and trigger are pressed. When the throttle is pushed all the way forward and pulled back again, the third axis indicator in the center should go up and down. After you've finished testing, quit by clicking on OK in the Test window, and OK in the General window. Note that the actual controls for the thumb button, trigger, and throttle are set within each individual game. Turn off your computer, and unplug the joystick from the computer's game port. Since these cables can sometimes cause problems, we suggest that your ST50 be connected directly to the game port. · Be sure to remove any existing controllers before you install the ST50, as noted in Section 2. 1 · The game port driver hasn't been installed properly. Whether you're cruising the skies in a jetliner, or heading for Why?the finish line in · Check your Game Controller Setup, as described an exciting race, in Section 2. Make sure that you have selected remember that the 3-axis, 2-button joystick option. Even if you have be aware of how already done this, recalibrating can sometimes you're sitting and how you're solve problems. stay in the same position for too · Recalibrate the unit, following the directions long, and be sure to take breaks now and then. Remember that the throttle is used to take a chance on straining your calibrate the third axis, and should be pushed all wrists, hands, or fingers!· To avoid potential problems and conflicts, we recommend that you remove any existing controllers before installing the ST50. I calibrated the ST50 and loaded my game, but the game instructions say I have to calibrate it again. · Most current games make use of the Windows® game controller and calibration information. [. . . ] In order to deal with your problems as quickly as possible, we ask that you please follow these guidelines when contacting us: · Have access to your computer when you call!If you are experiencing problems with one particular game, try to have that game loaded. · Provide us with other relevant information, such as your computer's make and model, details on your hardware and software, the version number of the game, etc. [. . . ]