User manual SAITEK R660 GT FORCE FEEDBACK WHEEL

[. . . ] Plug the USB cable into one of your computer's USB ports and click on Next. At the Registration screen, select Check this box to register now and follow the on-screen instructions, or you can choose to select this option later. For Vista users, the screen will once again ask Do you want to run this file?A screen will now appear saying A program needs your permission to continue. [. . . ] Please note that the force feedback effects will feel slightly stronger if this box isn't checked. The slider allows you to adjust the strength with which the wheel will centre itself if the Always On box is ticked. Deadzones The Deadzones tab allows you to change how far you move the wheel or pedals before they have an effect. Increasing the X Axis deadzone means you have to turn the wheel more to the left or right before it steers your car left or right. Increasing the Gas and Brake deadzones means you have to press down further on the pedals before they increase power or apply brakes. Nearly all the products that are returned to us as faulty are not faulty at all - they have just not been installed properly. If you experience any difficulty with this product, please first visit our website www. The technical support area will provide you with all the information you need to get the most out of your product and should solve any problems you might have. If you do not have access to the internet, or if the website cannot answer your question, please contact your local Saitek Technical Support Team. We aim to offer quick, comprehensive and thorough technical support to all our users so, before you call, please make sure you have all the relevant information at hand. To find your local Saitek Technical Support Center, please see the separate Technical Support Center sheet that came packaged with this product. FCC Compliance and Advisory Statement Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Operation is subject to the following two conditions: 1 This device may not cause harmful interference, and; 2 This device must accept any interference received, including interference that may cause undesired operation. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected; · Operation is subject to the following two conditions: 1 This device may not cause interference, and; 2 This device must accept any interference, including interference that may cause undesired operation of the device. [. . . ] This warranty is in lieu of all other expressed warranties, obligations or liabilities. Some states do not allow limitations on how long an implied warranty lasts, so the above limitations may not apply to you. iN NO EVENT SHALL WE BE LIABLE FOR ANY SPECIAL OR CONSEQUENTIAL DAMAGES FOR BREACH OF THIS OR ANY OTHER WARRANTY , EXPRESS OR IMPLIED , WHATSOEVER. Some states do not allow the exclusion or limitation of special, incidental or consequential damages, so the above limitation may not apply to you. [. . . ]