User manual SAITEK NOTEBOOK 800 DPI MOUSE

[. . . ] Adjust your chair and keyboard so your upper arms and wrists are straight. Can't get started - don't worry, we're here to help you!Nearly all the products that are returned to us as faulty are not faulty at all - they have just not been installed properly. [. . . ] This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: With your PC on, insert the Mouse's USB plug into one of your PC's USB sockets. Follow the device installation wizard to complete the installation of the new USB device to the system. Mouse not detected Make sure the mouse cable is plugged into the correct USB port. Refer to your computer documentation for the correct port configuration. You may have other system devices (eg, a modem card) that conflict with the mouse. check the IRQ/address settings of these devices for conflicts , and change the setting as required. Determine whether the problem is related to the mouse or the system, try the mouse on a second system or a different mouse on your current system. Reorient or relocate the receiving antenna; Increase the separation between the equipment and receiver; Connect the equipment into an outlet on a circuit different from that to which the receiver is connected; · consult the dealer or an experienced radio/TV technician for help. Saitek Industries, 2295 Jefferson Street, Torrance, CA 90501, USA Canada ICES-003 Operation is subject to the following two conditions: This device may not cause interference, and; This device must accept any interference, including interference that may cause undesired operation of the device. cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada. Conditions of Warranty 1 Warranty period is 2 years from date of purchase with proof of purchase submitted. Specifically excludes any damages associated with leakage of batteries. Note: Batteries can leak when left unused in a product for a period of time, so it is advisable to inspect batteries regularly. 4 Product must not have been damaged as a result of defacement, misuse, abuse, neglect, accident, destruction or alteration of the serial number, improper electrical voltages or currents, repair, alteration or maintenance by any person or party other than our own service facility or an authorized service center, use or installation of non-Saitek replacement parts in the product or the modification of this product in any way, or the incorporation of this product into any other products, or damage to the product caused by accident, fire, floods, lightning, or acts of God, or any use violative of instructions furnished by Saitek plc. [. . . ] iN NO EVENT SHALL WE BE LIABLE FOR ANY SPECIAL OR CONSEQUENTIAL DAMAGES FOR BREACH OF THIS OR ANY OTHER WARRANTY , EXPRESS OR IMPLIED , WHATSOEVER. Some states do not allow the exclusion or limitation of special, incidental or consequential damages, so the above limitation may not apply to you. This warranty gives you specific legal rights, and you may also have other rights which vary from state to state. [. . . ]