User manual SAITEK IFREEDOM A-250 WIRELESS SPEAKER

[. . . ] Find a free USB port (preferably on the front of your computer or on your keyboard) and insert the Wireless speaker system transmitter into it. Press the blue button switch on top of the transmitter for one second to turn it on. The button will flash blue while the transmitter is establishing a wireless connection and will stop flashing and remain lit when communication is established. Please see the Troubleshooting section at the end of this guide if your computer does not recognise the transmitter. [. . . ] Press the "+" button to increase volume until you can hear the music. Please note that you can also use rechargeable batteries in your wireless speaker system ­ these must be taken out of the battery compartment to be recharged. To save battery life or when the batteries have expired, if you are near a mains power source you can power the wireless speaker system using the AC Adapter supplied. Simply plug it into a mains socket and then plug the cable into the power socket on the rear right-hand side of the wireless speaker system. Note that the speaker system will only function at its highest volume when the connected to the AC Adapter. 5mm jackplug input, check that your music player's volume setting is not at 0. Check that the speaker system is within 30m range of your computer and that there are no solid metal barriers blocking the wireless signal. If necessary, move the speaker system nearer the computer and remove any large obstructions. Music is playing through my speaker system but the pause, previous track/next track buttons do not work. When I stop or play tracks directly on my computer's music player, the speaker system will no longer control the computer. When you first turn your speaker system on it will automatically tell your computer's music player to stop playing. The Saitek speaker system will then be able to directly control the stop and play functions on your music player. To avoid "confusing" the computer, always control tracks using your speaker system's controls and not your computer. If your music player does not respond to your speaker system's controls, quit and then restart the music player application. The Saitek A-250 Wireless speaker system is equipped with a backlit LCD display which indicates battery life, volume, play status, and wireless or wired connection. The screen backlighting illuminates when you press " "and after any key press. When you switch the wireless speaker system on the unit will automatically "look" for the wireless transmitter to connect. While the speaker system is looking for the transmitter, the LCD screen will show "-----" and the wireless indicator will flash to show that the wireless link is not established. When the transmitter has been discovered and both units are ready, the wireless indicator stops flashing and will show "OK". If the connection to the transmitter is lost or not established (perhaps because it is out of range), the LCD will show "-----" and the wireless indicator will flash again. [. . . ] The unit switches back to the wireless mode, and after the signal is found, the LCD shows OK. When the battery level is down to the last bar, the battery icon starts to flash and BATT is displayed on screen. If the " " button is pressed for 3 seconds, the audio source switches between the Wireless and the 3. 5mm jackplug (LINE) input (The default source is wireless when you initially turn on the speaker system). [. . . ]