User manual SAITEK CYBORG KEYBOARD

[. . . ] Game keys WASD keys Keyboard Arrow keys Cursor controls Lighting brightness Lighting colour Increase/decrease (brightness) or scroll through (colour) Caps/num/scroll locks First plug the USB cable marked "K/B" into one of your PC's free USB ports. If you intend to use headphones, speakers, headset or microphone, also plug the pink and green mini jackplugs into the corresponding audio in and out sockets of your PC. Now plug your headset, speaker cables etc into the pink audio in and green audio out sockets at the rear right side of your keyboard. [. . . ] If you do not have access to the internet, or if the website cannot answer your question, please contact your local Saitek Technical Support Team. We aim to offer quick, comprehensive and thorough technical support to all our users so, before you call, please make sure you have all the relevant information at hand. To find your local Saitek Technical Support Center, please see the separate Technical Support Center sheet that came packaged with this product. With your computer switched on, close down any programs that are currently running and insert the Installation CD into your CD-ROM drive. If the CD does not run automatically, select Start from the Windows® Taskbar, then Run and type D:\Setup. A screen will now appear saying A program needs your permission to continue. After reading the Disclaimer, select the I accept the terms of the Disclaimer option and click Next to continue. At the Registration screen, select Check this box to register now and follow the on-screen instructions, or you can choose to select this option later. Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Operation is subject to the following two conditions: 1 This device may not cause harmful interference, and; 2 This device must accept any interference received, including interference that may cause undesired operation. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected; Follow points 1 - 6 of the install procedure in A), then at the Software Setup screen, select Install the SST Programming Software and click Next. For Vista users, the screen will once again ask Do you want to run this file? [. . . ] This warranty is in lieu of all other expressed warranties, obligations or liabilities. aNY IMPLIED WARRANTIES , OBLIGATIONS , OR LIABILITIES , INCLUDING BUT NOT LIMITED TO THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE , SHALL BE LIMITED IN DURATION TO THE DURATION OF THIS WRITTEN LIMITED WARRANTY. Some states do not allow limitations on how long an implied warranty lasts, so the above limitations may not apply to you. [. . . ]