User manual SAITEK BRIDGE SHADOW

[. . . ] Please note, you can only adjust the standby values and not the active values. to make the standby values active , press the ACT/STBY switch to the right of the panel. The standby values you have input will now move from the standby section of the screen to the active section and vice versa. Adjusting the XPDR code To adjust the transponder squawk code, first select XPDR on the radio mode selector knob on the left of the panel. [. . . ] To adjust digits 3 and 4, press the ACT/STBY button to the right of the unit and adjust digit 3 by turning the outer rotary and digit 4 by turning the inner rotary. Troubleshooting The radio panel controls are automatically configured to interact with FS X software. When you open Microsoft FSX you will be asked "Do you trust this driver from Saitek?You will then be asked "Do you always want to load this plugin when launching Flight Sim X?If your FS X software does not recognise the radio panel, unplug the USB cable and plug it back in. If FS X appears not to load, this is because it is waiting for a prompt. View the prompt window, select it either by pressing Alt + tab or by clicking on the prompt on the Windows task bar. The prompt reads "Microsoft Flight Simulator security warning : will happen once after install". Click Run and when asked "would you like to designate this module?The Pro Flight Radio panel will not register automatically if you have installed the panel before installing FS X. to register the Pro Flight radio Panel with FS X , click on the "Launch the Flightsim X plugin manually" icon to re-run the program. FCC Compliance and Advisory Statement Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device must accept any interference received, including interference that may cause undesired operation. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: - Reorient or relocate the receiving antenna; - Increase the separation between the equipment and receiver; - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected; - Consult the dealer or an experienced radio/TV technician for help. Saitek Industries, 2295 Jefferson Street, Torrance, CA 90501, USA Canada ICES-003 Operation is subject to the following two conditions: 1. This device must accept any interference, including interference that may cause undesired operation of the device. Für Vista Benutzer: Wenn die Aufforderung "Do you want to run this program from Saitek?Beim Öffnen von Microsoft FSX erscheint die Frage "Do you trust this driver from Saitek? [. . . ] Beim Öffnen von Microsoft FSX erscheint die Frage "Do you trust this driver from Saitek?Danach erscheint die Frage "Do you always want to load this plugin when launching Flight Sim X?Die Eingabeaufforderung lautet: "Microsoft Flight Simulator security warning : will happen once after install" (Microsoft Flight Simulator Sicherheitshinweis: Erfolgt einmal nach der Installation). Quando aprite Microsoft FSX vi viene chiesto "Do you trust this driver from Saitek? [. . . ]