User manual SAGE SES875

[. . . ] we design and manufacture appliances with your safety foremost in mind. We also ask that you exercise a degree of care when using any electrical appliance and adhere to the following precautions. Before using for the first time, please ensure that your electricity supply is the same as shown on the rating label on the underside of the appliance. If you have any concerns please contact your local electricity company. [. . . ] When the STEAM/HOT WATER light stops flashing, return the dial back to STANDBY position. Then within 8 seconds, insert the steam wand tip (1­2cm) below the surface of the milk, close to the right hand side of the jug at the 3 o'clock position and quickly turn the dial back to the STEAM position. Pausing the steam avoids the milk splashing out of the jug (this pause function lasts for 8 seconds only). The indicator strip on the milk jug will change colour to highlight the exact milk temperature. Once the milk is at the correct temperature (60­65°C), return the dial to the STANDBY position BEFORE removing the jug. Then, with the steam wand tip directed over the drip tray, briefly turn steam on to clear any remaining milk from inside the steam wand. The illuminated button will indicate the current temperature selected. To adjust the water temperature, press one of the following buttons within 5 seconds of entering Advanced Temperature Mode. If no buttons are pressed within 5 seconds after entering Advanced Temperature Mode, no change will be made & the machine will return to STANDBY mode. After 5 minutes of continuous steaming, the machine will automatically disable the steam function. Set current month Soak lter for 5 min Replace lter after 90 days or after 40L The provided water filter helps prevent scale build-up in and on many of the inner functioning components. Replacing the water filter after three months or 40L will reduce the need to descale the machine. The 1 CUP button should flash continuously and remain constant once the descaling process has finished. To terminate the descaling within 25 seconds, press the 1 CUP button again. descale the steam and hot water components Descaling steam and hot water takes approximately 13 seconds and 8 seconds respectively. Descaling can be terminated prematurely by turning the steam dial to STANDBY. Descale Steam component by turning the steam dial LEFT towards the STEAM icon. Repeat processes to complete descaling After the above processes about half (0. Repeat steps 4-6 above to complete the descaling process to empty the solution in the tank. After descaling, remove the water tank and rinse thoroughly then refill with fresh cold water to the maximum capacity (2 litres) and repeat steps 4-6 to further cleanse the machine of any residue of the cleaning solution thoroughly. nOTE The machine turns off automatically if there is no action for 5 minutes in descaling mode. Descale Hot water component by turning the steam dial to the RIGHT towards the HOT This step is only required if there is a blockage between the grinding burrs and the grinder outlet. [. . . ] Ensure the STEAM / HOT WATER dial is completely rotated to the STEAM position. Milk not hot enough Heat milk until side of the jug becomes hot to touch. Water is automatically released into the drip tray after the steam and hot water functions to ensure the thermocoil is at the optimal temperature for extracting espresso. The machine is carrying out the normal operation of the 15 bar Italian pump. [. . . ]