User manual SAECO SPIDEM MY COFFEE MANUAL 2

[. . . ] Thank you for purchasing this highest quality espresso coffee machine and for your confidence in our company. Before operating the machine, we recommend carefully reading the operating instructions that explain how to use, clean and maintain it in perfect working order. Please refer an authorized dealer, or to Saeco, if you have any questions. When using electrical appliances, basic safety precautions should always be followed, including the following: 1. [. . . ] At this point, the temperature light (19) will begin to blink slowly, indicating that the machine is in warm-up mode. Note: Before starting the machine after long periods of inactivity or if the water tank has been completely emptied, it is advisable to prime the circuit. When warm-up is complete, the machine carries out a rinse cycle of the internal circuits. A small amount of water will be dispensed; in this phase the lights blink cyclically in a counter clockwise direction. To brew coffee, dispense hot water or steam, and for proper use of the machine, carefully follow the instructions provided. The machine allows for certain adjustments that will permit you to use it to its full potential. Coffee is a natural product and its features may change according to its origin and blend. The Spidem coffee machine is equipped with a self-adjusting system that allows using all types of coffee beans available on the market (except caramelized ones). For this reason we recommend brewing several cups of coffee before adjusting the coffee grinder. The grinder adjustment knob, inside the coffee bean hopper, must be turned only when the grinder is running. Do not pour ground and/ or instant coffee into the coffee bean hopper. Switch the power button to off and remove the plug from the socket before carrying out any type of operation inside the bean hopper. The machine lets you make slight adjustments to the coffee grinder to adapt it to the kind of coffee used. This adjustment is carried out by adjusting the knob found on the inside of the coffee bean hopper; this knob must be pressed and turned only with the grinder adjustment key (22) provided with the coffee machine. 28-29) - While the grinder is running, press and turn the knob (with the supplied key) one notch at a time and brew 2-3 cups of coffee; the grinder adjustment may only be noticed in this way. The references located inside the coffee bean hopper indicate the grind setting. The machine allows you to adjust the amount of brewed coffee according to your tastes and/or the size of your coffee cup(s). Each time you press and release the brew button (14) or (15) the machine brews a pre-programmed amount of coffee, which is different for each button. Each button may be individually programmed for a specific brew setting. Warning: at the beginning, short spurts of hot water may come out: Danger of scalding. The steam / hot water wand may reach high temperatures: never touch it with bare hands. Before dispensing hot water, make sure that the green temperature ready light (19) is on. [. . . ] Between each cup, you must allow the descaling solution to take effect for about 10-15 minutes, turning the machine off by pressing the power button (17). Continue until the descaling solution runs out and the water tank is empty. When the descaling solution is finished, rinse the water tank and fill it with fresh water. 8) - Turning the knob (10) clockwise, empty the entire contents of the water tank; to stop dispensing, turn knob (10) counter-clockwise. [. . . ]