User manual SAECO ROYAL COFFEE BAR MANUAL 2

[. . . ] We congratulate for having bought this top-quality espresso machine and thank you for choosing Saeco. Before operating the machine, we recommend to read the following instructions thouroughly which explain how to use, clean and maintain the machine. Dear Customer, This fully automatic coffee machine allows the brewing of either espresso or normal coffee, using both bean and pre-ground coffee. This coffee machine, as all electric appliances, must be used with particular caution to avoid harm to people or damages to the machine itself. [. . . ] If the water supply function is off, the machine will use the water tank as a stock. Important: when using the machine for the first time, passing from the water tank to the water supply in the programming mode, a DRAINAGE must be carried out, as described at page 86. Rinsing cycle This appliance is equipped with a rinsing cycle program for the usual, daily and weekly rinsing. If regularly used, this program effectively eliminates the greasiness of coffee in inaccessible parts and avoids alterations in the taste of coffee. Depending on the way the appliance is used, it is advisable to rinse it every month or after max. The rinsing cycle lasts about 5 minutes, and it is divided into 4 cycles, including the rinsing with cold water. Connect the machine to a drinking water pipe having a pressure between 1, 5 and 8 bar. To do this, use a loading tube with adequate characteristics and connect it to the G3/4" sleeve placed on the rear part of the frame. Important: It is advisable to connect the machine to water treated with a descaling device, especially in case of hard water or water high in calcium and magnesium. Empty coffee bean container When coffee beans run out, the coffee grinder stops and the following message is displayed: "COF. bEANS EMPTY " "READY FOR USE " Fill the container and restart the cycle. Empty water tank When water runs out, the program stops automatically and the following message is displayed: "WATERTANK EMPTY Fill the tank and restart the cycle. 33 The coffee dosage adjustment lever (18) allows the selection of the grinding coffee amount from 6 to 9 grams. Important: before starting the rinsing cycle, always fill completely the water tank and put a capacious container (min. Grounds container warning light As soon as there are 30 grounds in the container, The following message is displayed: "DREGDRAWER FULL "READY FOR USE " " The machine does not stop: remove the grounds container and empty it. Grind adjustment If the coffee flows too quickly (coarse grind) or too slowly (fine grind) into the cup, adjust coffee grinder. On the contrary, should grinding be too fine, adjust it on a higher value (e. In case of a prolonged period of idleness, it is advised to switch the main switch (4) off; once switched on again, the machine will be ready to be used within two minutes. Switching off the machine Switch the machine off only after the coffee cycle has been concluded. BREWING Cup level filling This machine allows the precise dosage of the coffee quantity, according to the cup dimension. To set the quantity of coffee to be dispensed, it is necessary to press the relevant selection key till the desired quantity of coffee is obtained (max. During this operation, the following message is displayed: "1 SMALL COFFEE "PROGR. [. . . ] As soon as descaling has been performed, rinse the water tank (11) thoroughly and fill it with fresh water. ) flow out of the steam/hot water dispensing tube in order to rinse away residues. Important: A periodic descaling ensures a correct machine functioning and avoids expensive repairs. The machine warranty does not cover damages occurring as a result of the non-observance of descaling procedures, improper use and nonobservance of any other instruction contained herein. [. . . ]