User manual SAECO INCANTO SIRIUS

[. . . ] Read these operating instructions carefully before using the machine When using electrical appliances, basic safety precautions should always be followed to reduce the risk of fire, electric shock, and/or injury to persons, including the following: 1 Read all instructions and information in this instruction book and any other Literature included in this carton referring to this product before operating or using this appliance. 3 To protect against fire, electric shock and personal injury do not immerse cord, plugs or appliance in water or other liquid. 4 Close supervision is necessary when any appliance is used by or near children. Allow to cool before putting on or taking off parts, and before cleaning the appliance. [. . . ] Note: You must load the circuit before starting up the machine for the first time, if it has been inoperative for a lengthy period or if the water tank has been completely emptied. Moreover, the circuit must be loaded every time the message "VENTILATE" is displayed. The fineness of the grind may be Coffee flows out more Coffee flows out more Adjustment may be made only while the coffee grinder is operating. If you do not obtain the desired result, try using different coffee blends. If you set the grinder on too fine a grind (knob turned all the way anticlockwise) and the SBS control on "strong" (toward the right), coffee may flow out in a slow trickle or not at all. COFFEE DOSE ADJUSTMENT - You must adjust the dose before dispensing coffee. BIG CUPS To place the brew unit again in its position, pull it until it fits in. Strong black coffee To use big cups, press the button and push the brew unit until the end. The brew unit, press the button corresponding To the type of coffee Desired and keep it pressed while coffee When the cup has filled to the desired level, release the button; the machine is now programmed to dispense the quantity of coffee you have chosen. Before dispensing hot water, check on the display that the function has been selected. Once for 1 coffee When the machine stops making the coffee, remove the cup or cups. Before dispensing hot water, check on the display that the function has been selected. The machine will signal the function Move the cup in a circular fashion to heat the milk evenly. Remove the cup and position it beneath the brew unit Dispense coffee into the cup to prepare a delicious cappuccino. You can use any commercially available non-toxic, non-harmful descaling product for coffee machines. Descaling is necessary every 3-4 months, when there is a reduction in the water capacity. The machine must be on; it automatically controls the distribution of the descaling solution. The machine signals when Press the MENU button Fill the water tank with the Place a large receptacle Turn the knob to open the When the descaling cycle is completed, close the knob. mACHINE IS DESCALING OPEN KNOB The descaling cycle can be cut short by closing the knob. Rinse out the tank and fill it Press the button to confirm with fresh drinking water. The machine will start completed, close the knob If the descaling cycle is interrupted by switching off the machine, it will automatically resume when the machine is switched back on. Rinse out the tank and fill it Press the button to confirm with fresh drinking water. [. . . ] This is a factory-set function that automatically switches the machine into "Standby" when 3 hours have elapsed since a coffee was dispensed. When the function ap- Use the buttons to Press the "OK" button to pears, select it using the adjust the timer setting. This function is used to rinse all the coffeedispensing parts with water. Warning: a large quantity of water may be discharged from the coffee brew unit. [. . . ]