User manual SAECO INCANTO

[. . . ] To disconnect, turn switch to "OFF", then remove plug from wall outlet. Any servicing, other than cleaning and user maintenance, should be performed by an authorized service centre. To reduce the risk of fire or electric shock, do not disassemble the base. 1 Check voltage to be sure that the voltage indicated on the nameplate agrees with your voltage. [. . . ] - Warning: contact with hot water, steam or and hot water/steam nozzle may cause burns. - Do not use the appliance if it malfunctions or you suspect damage, e. - To prepare coffee, dispense hot water, froth milk or heat beverages using steam. Never place any substances in the containers other than those specified in the instruction manual. When you fill a container, make sure all nearby containers are closed. Fill the water tank only with fresh drinking water: hot water and/or other liquids may damage the machine. Do not introduce your fingers or any material other than coffee beans into the coffee grinder. Before attempting to access the inside of the coffee grinder, switch OFF the machine and remove the plug from the electric socket. Do not put coffee beans or instant coffee into the ground coffee container. - Maintain a distance of 10 cm from walls and electric or gas burners. - Do not keep at temperatures below 0 °C; the appliance may be damaged by freezing. - The power cord must not be damaged, secured with clamps, placed on very hot surfaces etc. To guarantee safety, you should use only original spare parts and accessories. For a correct disposal of the machine, please follow the instructions contained on the last pages of the manual Coffee bean container Cup plate Preground coffee dispenser lid Control panel Water tank Service door Steam knob Cleaning brush Preground coffee measure Coffee bean container lid Water tank lid Dose adjustment knob Tray full indicator Swivel base Preground coffee selector button Brew group Dregs drawer Small coffee button Steam button Descaling button Warning light Coffee bean container and dregs drawer indicator light Water tank and circuit loading indicator light The messages displayed by the machine during operation are shown on page 34. Important warning for using the "Aqua Prima Filter" can be found at page 35. Note: You must load the circuit before starting up the machine for the first time, if it has been inoperative for a lengthy period or if the water tank has been completely emptied. The circuit must also be loaded each time the light flashes: When the indicator lights are fixed, the machine is ready for use. Check the dater on "Aqua Prima" filter; if filter is past its date, replace it with a new one. If you do not obtain the desired result, try using different coffee blends. COFFEE DOSE ADJUSTMENT - You must adjust the dose before dispensing coffee. When the cup has filled to the desired level, release the button; the machine is now programmed to dispense the quantity of coffee you have chosen. COFFEE IN CUPS To adjust the quantity of coffee dispensed to the size of your cups. [. . . ] If the "Aqua Prima" filter has NOT been installed, set the machine according to these indications. When this function is enabled, the internal machine circuits will be rinsed immediately after the warming-up phase to ensure that coffee is prepared with fresh water only. In all new appliances this function has already been enabled in the factory. With the pre-brewing process the coffee is slightly moistened before actual brewing. [. . . ]