User manual SAECO D.A. COMBISNACK

[. . . ] Vending machine ACCESSORIES AND PAYMENT SYSTEMS D. A. COMBISNACK Type: D. A. COMBISNACK Espresso Italia PTY LTD www. espressoitalia. com. au Freecall 1300 660 976 USE AND MAINTENANCE English Contents 123456789DIAGRAM OF CONNECTIONS TO THE KEYPAD BOARD/CPU:. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] 24 - Espresso Close the vending machine lower door. Italia PTY LTD www. espressoitalia. com. au 9 Freecall 1300 660 976 English 5- FLOAT KIT - It allows the display to read the discharge fluid maximum level. In this condition, no hot beverage is available and the display will read "ERROR 09". The float can be installed in different positions according to whether the machine is connected to a water network (22 L tank) or uses an independent tank (7L tank). Slide the other end of the reed wiring inside the hole (ref. 1 basket set for discharge fluid level 2 screws 1 reed wiring - fig. The drain level control system doesn't work if two sensors are connected. If it is applied to the water network version, it is necessary to remove the 22L tank (ref. If it is applied on the independent tank version, it is necessary to remove the 7 L tank (ref. If no password has been assigned you enter the programming menu directly. Important If vending machine was assigned a password to enable the programming menu, "PASSWORD 0000" will appear on display with a flashing cursor on the first digit. The vending machine can be fitted with an electromechanical pulse counter (24V DC) which will count the number of coffees or the total beverages brewed by the machine. Assembly kit (fig. 35 Installation Open the upper door and fasten the pulse counter (ref. 35). To exit the programming menu and return to the normal operation of the vending machine: - press key 1 again; - remove the key from the safety switch to turn off the vending machine; - close the door and wait for the self-configuration process to end. SISTEM MANAGEMENT VM CODE 0000 STOP MIN. 36 Couple the pulse counter wiring with the "CN14" connector of the board (fig. TEMPERATURE 108 Entries selectable only with complete menus COLD TEMPERATURE 6 COMPRESSOR YES DRAINAGE TANK NO MECH. 38 Espresso Italia PTY LTD www. espressoitalia. com. au Freecall 1300 660 976 English 7- WATER SOLENOID VALVE KIT - Open the upper door and loosen the screw (fig. 42) fixing the block support plate. It is possible to brew hot water alone by installing the required kit Assembly kit (fig. 40) by untightening the screws and disconnecting the ground wiring placed on the machine. fig. 41) and hold the latter to avoid any excessive stress to the block support plate. 41 Espresso Italia PTY LTD www. espressoitalia. com. au 13 Freecall 1300 660 976 English - Screw the nut and fix the OR (ref. Remove the block support from its seat and screw the solenoid valve in the hole (fig. The solenoid valve must be placed with fastons upwards Reinstall the block support in their seat and tighten the screws. - Insert the pipe clamp (ref. 48) at the solenoid valve outlet and position the pipe retaining spring. Slide the other end of the pipe inside the assembly plate passage hole (ref. 46) that fastens the two unused cables. - Fasten the pipe end with fitting to the spout (fig. [. . . ] It is advisable to carry out all the electrical connections while the V. M. 90 - Reassemble the rear panel and close the upper front door. Espresso Italia PTY LTD www. espressoitalia. com. au 23 Freecall 1300 660 976 English 13 - SAECO WATER SOFTENER SUPPORT This support allows fixing the water softener supplied by Saeco in a proper way. - Insert the water softener (ref. 92 Installation Remove the machine rear panel and assemble the water softener support (ref. 93 24 Espresso Italia PTY LTD www. espressoitalia. com. au Freecall 1300 660 976 English 14 - PROGRAMMING KEY The programming key allows the set data transfer in the following programming menu entries: PRICE MANAGEMENT. [. . . ]