User manual RYOBI TURF-POWER-780TP

[. . . ] A wrench or a key left attached to a rotating part of the power tool may result in personal injury. This enables better control of the power tool in unexpected situations. If devices are provided for the connection of dust extraction andcollection facilities, ensure these are connected and properly used. [. . . ] Do not use a power tool while you are tired or under the influence of drugs, alcohol or medication. The correct power tool will do the job better and safer at the rate for which it was designed. Any power tool that can not be controlled with the switch is dangerous and must be repaired. Disconnect the plug from the power source before making any adjustments, changing accessories, or storing power tools. Such preventive safety measures reduce the risk of starting the power tool accidentally. Store idle power tools out of the reach of children and do not allow persons unfamiliar with the power tool or these instructions to operate the power tool. Check for misalignment or bindling of moving parts, breakage of parts and any other condition that may affect the power tools operation. Properly maintained cutting tools with sharp cutting edges are less likely to bind and are easier to control. , in accordance with these instructions and in the manner intended for the particular type of power tool, taking into account the working conditions and the work to be performed. WARNING Always wear safety goggles or safety glasses with side shields during power tool operation or when blowing dust. WARNING To avoid serious personal injury, always remove thebattery pack from the tool when cleaning or performing any maintenance. Place brads in the centre of the channel with "T" head sitting on the slot base. Test on a scrap piece of the same material you are using to achieve the desired results. Most plastics are susceptible to damage from various types of commercial solvents and may be damaged by their use. WARNING Do not at any time let brake fluids, gasoline, petroleum-based products, penetrating oils, etc. Chemicals can damage, weaken ordestroy plastic which may result in serious personal injury. Only the parts shown on the parts list are intended to be re-paired or replaced by the customer. Press the activation foot of the nailer/stapler down against the workpiece to disengage the safety interlock. [. . . ] The activation foot must be depressed before the switch trigger is depressed. Release the trigger switch and activation foot before driving another brad or staple. Note: You must release the activation foot and switch trigger after each brad or staple to reset the tool. [. . . ]