User manual RYOBI TURF-POWER-700TP

[. . . ] Never carry the charger by the cord or yank it to disconnect it from the socket. It is safer than using your hand and it frees both hands to operate the tool. Before further use of the tool, a guard or other part that is damaged should be carefully checked to determine that it will operate properly and perform its intended function. Check for alignment of moving parts, free running of moving parts, breakage of parts, mounting and any other conditions that may affect its operation. [. . . ] Check for alignment of moving parts, free running of moving parts, breakage of parts, mounting and any other conditions that may affect its operation. A guard or other part that is damaged should be properly repaired or replaced by an authorized service centre unless otherwise indicated in this instruction manual. Be sure switch is in the locked or off position before inserting battery pack. Carrying tools with your finger on the switch or inserting the battery pack into a tool with the switch on, invites accidents. Proper footing and balance enable better control of the tool in unexpected situations. Dust mask, nonskid safety shoes, hard hat, or hearing protection must be used for appropriate conditions. The correct tool will do the job better and safer at the rate for which it is designed. Disconnect battery pack from tool or place the switch in the lock off position before making any adjustments, changing accessories, or storing the tool. Such preventive safety measures reduce risk of starting the tool accidentally. Store idle tools out of reach of children and other untrained persons. Place the battery pack in your saw aligning raised rib on battery on battery pack with groove in saw's battery port. Metals such as sheet steel, pipe, steel rods, aluminum, brass, and copper may be cut with your saw. Cutting oil will also keep blades cool, increase cutting action, and prolong blade life. Clamp the work firmly and cut close to the clamping point to eliminate any vibration of the work being cut. When cutting conduit pipe or angle iron, clamp work in a vise if possible and cut close to the vise. To cut thin sheet material, "sandwich" the material between hardboard or plywood and clamp the layers to eliminate vibration and material tearing. WARNING Do not at any time let brake fluids, gasoline, petroleum-based products, penetrating oils, etc. WARNING Do not attempt to modify this tool or create accessories not recommended for use with this tool. Any such alteration or modification is misuse and could result in a hazardous condition leading to possible serious personal injury. Most plastics are susceptible to damage from various types of commercial solvents and may be damaged by their use. [. . . ] Any such alteration or modification is misuse and could result in a hazardous condition leading to possible serious personal injury. Most plastics are susceptible to damage from various types of commercial solvents and may be damaged by their use. VARNING Se till att sågklingan inte rör vid arbetsstycket förrän motorn nått högsta möjliga varvtal ; detta kan leda till att man förlorar kontrollen och förorsaka allvarliga kroppsskador. Dup ce ai scos bateria, nu mai exist riscul de pornire accidental care poate cauza rniri corporale grave. [. . . ]