User manual RYOBI TFI180I SCHEMA ELECTRIC

[. . . ] ~ Do not dry articles that have been previously cleaned, washed, soaked or spotted with gasoline, dry-cleaning solvents or other flammable or explosive substances. They may give off vapors that could ignite or explode. ~ Do not use fabric softener sheets to eliminate static in this dryer. Best results are achieved when a liquid softener is used in the washer. ~ Do not use heat to dry articles containing foam rubber or similarly textured rubber-like materials, or items containing hair spray, nail polish remover or similar substances, wax or chemicals from buffing. ~ Do not allow children to play on or in the appliance. Close supervision is necessary when the appliance is used near children. [. . . ] ^ Open the door. , CAUTION - Do not touch the rear of the drum while adding or removing items!^ Turn the dryer back on with the "On/Off" button. 12 Child lock Child lock When activated, the child lock prevents the dryer from being operated by locking the control panel functions. Press and hold the "Anti-crease" and "DRYNESS" buttons at the same time, hold until step 5. Should the container be full when the tumble dryer is started, or if it becomes full during normal operation: ­ The "Container" indicator will light. ^ Pull out the container slightly to the right with both hands. ^ Hold the cap open while emptying the container. ^ When the container is empty, push it back into its opening until it clicks into place. Do not drink the condensed water! 16 Dryer care Cleaning the condenser Removing the condenser ^ Open the door. , To reduce the risk of electric shock, disconnect the dryer from the power supply by shutting off the power main, tripping the circuit breaker or unplugging the power cord before performing maintenance. Detergent residues, hair and lint in the drying air can penetrate filters and clog the condenser. Particles from the cool air sucked in from the install location can cause blockages. ^ Clean if necessary. ^ Open the access panel, located on the lower left corner of the machine, using the yellow tool supplied with the machine. Hold the panel when opening it. ^ Remove the panel up and out of the condenser access area. Take items out immediately after the end of the program while still slightly damp. Allow items to air dry. Smooth Sturdy Fluff - TIMED CYCLES 20 min 45 min Available drying options Gentle, Anti-crease - Frequently asked questions What if the dryer will not run?Add fabric softener to laundry when washing or select the "Less Dry" setting on the dryer. Solution See "Changing the light bulb. " Solution Make sure the dryer is on. Close the door properly. What if the "Child Lock" indicator flashes after turning the dryer on and a program cannot be started?See "Child Lock. " What if the program stops, the "End/Anti-crease" indicator lights and the buzzer sounds?Single items should be dried with "Sturdy" or a timed program and dry items in the "Fluff" program. 21 Frequently asked questions What if the "Filter/Vent" fault indicator is lit?Open a window or door to increase airflow. What if the program runs too long or stops?Clean the lint filters (see "Dryer care"). The laundry was not spun sufficiently in Select a higher spin speed in the wash the washer. Possible fault The load contained too many dissimilar items (size and fabric. ) What if water has collected around the drum opening?Remove any blockages. 22 After sales service Repairs In the event of a fault which you cannot fix yourself, please contact Miele's Technical Service Dept. [. . . ] The cover plate of the built under kit replaces the appliance lid and ensures electrical safety. The electrical connection should be near the dryer and accessible at all times. Extended machine feet* are recommended at a built-in height of more that 33 1/16" (840 mm). Remove the original machine feet and replace them with the extended ones. [. . . ]