User manual RYOBI SC162VS

[. . . ] The high pressure may cause materials to bounce off surfaces at speed; therefore protective clothing and safety goggles MUST BE WORN. DO NOT use the cleaner if the high pressure hose is dam- 10 Check that the data plates are affixed to the cleaner, if not, inform your dealer. Cleaners without plates must NOT be used as they are unidentifiable and potentially dangerous. Before pressing the trigger, GRIP the gun firmly to counteract the recoil. [. . . ] 9 Before using the cleaner, CHECK every time that the screws are fully tightened and that there are no broken or worn parts. 10 Only USE detergents which will not corrode the coating materials of the high pressure hose/electrical cable. DO NOT tamper with or with or alter the calibration of the safe- ENSURE that all people or animals keep a minimum distance of 16 yd. - Water outlet (OULET) - Water inlet with filter (INLET) - High pressure rotating nozzle kit (optional accessory) - Adjustable spray nozzle - Use · Maintenance handbook - Power supply cable with plug - Lance - Gun with safety catch - High pressure hose - Nozzle cleaning tool - Motor switch - Adjustable foam unit GENERAL RULES The USE and MAINTENANCE manual constitutes an essential part of the cleaner equipment and should be kept in a safe place for future reference. If you sell the cleaner, the manual should be handed on to the new owner. Before starting the cleaner, make sure that it is receiving water correctly. If you are too far from the object you wish to clean, do not move the cleaner nearer by pulling on the high pressure hose; use the handle provided. In versions not equipped with TSS device, do not operate the cleaner for more than 1-2 minutes with the gun closed as this could damage the seals. The cross-section of any extension cables used must be proportional to their length, i. The longer the extension cable, the greater the crosssection; cables with a protection level of "IPX5" must be used. 1 Set the adjustable head in the "FAN JET" position, then fit the foam unit on the head and fix it in position. 1 The cleaner is equipped with a nozzle for adjustment of the jet from concentrated to fan. 2 It is also equipped with the foam unit for detergent distribution, with adjustment of the quantity of detergent using the knob M. ZLE (Where fitted) For increased washing power, use the rotary nozzle kit as follows: Turn off the high pressure cleaner Unscrew the adjustable head and fit the rotary nozzle onto the lance. RECOMMENDED CLEANING PROCEDURE Dissolve dirt by applying detergent with the fan jet to the dry surface. Leave the detergent to act for 1 to 2 minutes, but do not allow to dry out. Apply the high pressure jet, keeping the nozzle at least 30 cm (10 in. Discharge residual pressure by pressing the trigger until no more water comes out of the adjustable nozzle. Operate the cleaner with noncorrosive/non-toxic antifreeze before storing for the winter. Before working on the cleaner, disconnect the plug from the power supply socket. [. . . ] Before working on the cleaner, disconnect the plug from the power supply socket. To ensure good performance, check and clean the suction and detergent filters after every 50 hours of operation. Working through the hole on the rear, RELEASE the motor using a screwdriver (for models with this feature). The pump does not operate at the prescribed pressure Sudden changes in pump pressure The motor buzzes but fails to start Motor does not start Water leakages Excess noise Oil leaks For TSS MODELS ONLY: Motor starts even though the trigger is released For TSS MODELS ONLY: No water when lever is operated (when supply hose is connected) Power cable damaged Nozzle worn Water filter fouled Water supply pressure low Air being sucked into the system Air in pump Replace nozzle Clean filter Turn on the water supply tap fully Check that hose fittings are tight Switch off the cleaner and operate the gun until a steady flow of water is obtained. [. . . ]