User manual RYOBI RYAN-264-1

[. . . ] Before further use of the tool, a guard or other part that is damaged should be carefully checked to ensure that it will operate properly and perform its intended function. Check the mounting and any other condition that may affect tool operation. A guard or other part that is damaged should be properly repaired or replaced by an authorised service centre unless otherwise indicated elsewhere in this instructions manual. have defective switches replaced by an Authorised Ryobi Service Centre. [. . . ] Warning The use of any accessory or attachment other than those recommended in this user's manual may present a risk of personal injury. Wherever there are facilities for fitting a dust extraction system, make sure it is properly connected and correctly used. Important It is imperative to follow all national safety regulations concerning installation, operation and maintenance of the tool. Noise level (or sound pressure level) in the work area can exceed 85 dB(A). In this case, operators should take appropriate measures to ensure sound insulation and wear ear protectors. Important To protect yourself from the risk of electric shock, injury and fire when using an electric tool, it is imperative to take the following basic safety precautions. Before you use your tool, read these instructions carefully and make sure that you understand them thoroughly. Make sure that the supply voltage (Volts) used corresponds to the voltage marked on the tool's rating plate. Before drilling, use a line detector to locate concealed electric, water or gas lines in walls. Always pull the plug out of the socket before cleaning your tool or changing accessories. Your hammer drill is equipped with a hammer stop facility for smooth drilling. Clean the bit and grease it with a thin layer of machine grease before inserting it into the chuck. Push and rotate the dust-free tool into the bit holder as far as it will go. You can use the selector to change modes even when the hammer drill is operating (at low speed). The selected mode is only activated once the variable switch (2) is pressed to start the tool. Speed control The speed of the drill may be varied by increasing the pressure exerted on the trigger (2). The mode selector on the RYAN-264-1 features a third position, Rotation Stop Mode " ", which stops the rotation of the tool whilst maintaining the hammer action. This feature enables the tool to be used for chiselling, when fitted with the appropriate bit. The direction of rotation of the drill may be changed by the use of the reverse lever on the switch, situated above the trigger. The position of this should only be changed when the drill is at a standstill. [. . . ] The position of this should only be changed when the drill is at a standstill. Unplug the hammer drill before making any adjustment, servicing or cleaning the tool. At the end of your work, to prevent dust deposits you should use compressed air (max. This tool features a live tool indicator (7) which illuminates as soon as the tool is connected to the supply. [. . . ]