User manual RYOBI RYAN-264

[. . . ] Rubber gloves and non-skid footwear are recommended when working outdoors. Never carry the tool by the cord or yank it to disconnect it from the socket. It is safer than using your hand and it frees both hands to operate the tool. Your tool must be disconnected when not in use, before servicing, and when changing accessories such as blades, bits and cutters. [. . . ] Do not carry the plugged-in tool with a finger on the variable switch. When the tool is used outdoors, use only extension cords intended for outdoor use. Before further use of the tool, a guard or other part that is damaged should be carefully checked to ensure that it will operate properly and perform its intended function. Check the mounting and any other condition that may affect tool operation. A guard or other part that is damaged should be properly repaired or replaced by an authorised service centre unless otherwise indicated elsewhere in this instructions manual. have defective switches replaced by an Authorised Ryobi Service Centre. Warning The use of any accessory or attachment other than those recommended in this user's manual may present a risk of personal injury. Wherever there are facilities for fitting a dust extraction system, make sure it is properly connected and correctly used. Noise level (or sound pressure level) in the work area can exceed 85 dB(A). In this case, operators should take appropriate measures to ensure sound insulation and wear ear protectors. You can use the selector to change modes even when the hammer drill is operating (at low speed). The selected mode is only activated once the variable switch (2) is pressed to start the tool. Clean the bit and grease it with a thin layer of machine grease before inserting it into the chuck. Push and rotate the dust-free tool into the bit holder as far as it will go. The rotational direction switch (2) can only be activated when the tool is at a standstill!Speed control You can modify the speed at any time by pressing on the variable switch (2). the more you press on the variable switch (2) , the greater the speed. Lock-on button If you want to keep your hammer drill operating at a constant speed, press the lock-on button (3) while pressing the variable switch. To unlock this function, briefly press the variable switch (2) then release it. For reasons of safety, only use the hammer drill when it is fitted with the auxiliary handle. [. . . ] For reasons of safety, only use the hammer drill when it is fitted with the auxiliary handle. Rotate the auxiliary handle anticlockwise until your are in a safe and comfortable working position. Unplug the hammer drill before making any adjustment, servicing or cleaning the tool. At the end of your work, to prevent dust deposits you should use compressed air (max. [. . . ]