User manual RYOBI RS112

[. . . ] Accessories that may be suitable for one tool may create a risk of injury when used on another tool. Guard against electric shocks ­ avoid body contact with earthed surface (e. Hold the tool by insulated gripping surfaces when performing an operation where the cutting tool may contact hidden wiring. Make sure the cord is located so that it will not be stepped on, tripped over or otherwise subjected to damage or stress. [. . . ] Through sawing operations are those in which the blade cuts completely through the work piece when ripping or crosscutting. Always use either the fence or the mitre gauge to position and guide the work. Use only saw blades for which the maximum possible speed is not less than the maximum spindle speed of the tool and the material to be cut. Never stand or have any parts of your body in line with the path of the saw blade. Feed the work into the blade or cutter AGAINST the direction of rotation only. Never attempt to free a stalled blade without first turning the saw OFF. When transporting the machine use only transportation devices and do never use guards for handling or transportation. During transportation the upper part of the saw blade should be covered; for example by the guard. Use an extension table for supporting long workpieces during cutting operation. Input voltage Watts Blade diameter Bore size No load speed Depth of cut at 90° Depth of cut at 45° Main table size Extension table size Sound pressure level Net weight 110V / 230 V ~ 50 Hz 1500 W 254 mm 30 mm 4500 min-1 80 mm 50 mm 638 x 430 mm 638 x 260 mm 99 dB(A) 35. This machine is designed to rip and cross cut wood exclusively up to maximum thickness of 80 mm. Turn the adjustment nut so that the blade is on the 45º position and then tighten the lock nut. Crosscutting is cutting wood across the grain at 90° or square with both the edge and the flat side of the wood (Fig. The mitre gauge can be used on either of the grooves in the table, by doing that, remove the screw at the rear end in the groove, reassemble it afterward. WARNING Before turning the machine ON, make sure the blade guard is correctly installed and operating properly. Mitre crosscutting is cutting the wood at an angle other than 90° with the edge of the wood (Fig. Your Performance Power table saw features an overload reset button (14). In the event that your saw turns off during operation, turn the saw off and allow the motor to cool down for approximately 3 minutes. If the saw does not turn on, turn the switch off and check all cords for proper connection and retry. If it turns on and then cuts off while you are working, you may be trying to feed the workpiece too quickly or may be operating with a dull blade or may be trying to operate on a circuit providing insufficient voltage. Bevel crosscutting is the same as crosscutting except that the wood is also cut at an angle other than 90° with the flat side of the wood (Fig. Use the mitre gauge in the groove to the right side of the blade so the blade guard will not interfere. [. . . ] Always use the push stick to feed the workpiece until it is clear of the table (Fig. Always make sure the machines plug has been removed from the mains power source before changing brushes, lubricating or when doing any works or maintenance on the machine. After each use, check your machine for demage or broken parts and keep it in top working condition by repairing or replacing parts immediately. To assure safety and reliability, all repairs with the exception of externally accessible brushes should be performed by AUTHORISED SERVICE CENTRE or any other authorised service centre or organisations. [. . . ]