User manual RYOBI RPW120X

[. . . ] RPW120X Electric Pressure Washer OPERATOR'S MANUAL (Original Instructions) WARNING! To reduce the risk of injury, the user must read and understand the operator's manual before using this product. Thank you for your purchase. RPW120X manual. indd A1 09-12-15 9:22 ENGLISH(Original Instructions) INTENDED USE The cleaner is intended only for the cleaning of vehicles, boats, buildings, etc, by the removal of stubborn dirt using clean water and chemical detergents. For domestic use only, not for professional use, and only for operation at temperatures above 0° C . The jet must not be directed at persons, animals, electrical devices, or the machine itself. [. . . ] Use of this product with damaged or missing parts could result in serious personal injury. WARNING: Do not attempt to modify this product or create accessories not recommended for use with this product. Any such alteration or modification is misuse and could result in a hazardous condition leading to possible serious personal injury. Failure to comply could result in accidental starting and possible serious personal injury. Lift the machine and slide the axle into the wheel mounting hole in the machine base as shown. Push the hitch pin into the hole on the end of the axle to secure the wheel assembly. Depress the button on the handle assembly and insert into the holes on the pressure washer. Press down on the handle assembly until the button on the handle clicks into place. Push the two ends of the gun/lance together so that the holes inside each end are aligned. Lower the locking collar and rotate counter clockwise to tighten securely. Insert the connector on the end of the high pressure hose collar into the gun. Slide the collar over the coupler turning the collar clockwise to tighten securely. Insert the connector on the end of the high pressure hose collar into the pump outlet coupler. Slide the collar over the coupler turning the collar clockwise to tighten securely. The TSS will activate when user releases the spray gun trigger and will automatically shut the unit off. Before connecting the garden hose to the pressure washer: Run water through the garden hose for 30 seconds to clean any debris from the hose. If the filter is damaged, do not use the machine until the screen has been replaced. RPW120X manual. indd Sec2:6 09-12-15 9:22 ENGLISH(Original Instructions) If the filter is dirty, clean it before connecting the garden hose to the machine. CAUTION: When connecting the appliance to the water supply mains (not public drinking water supply mains), please observe the local regulations of local boards or local water supplier. To ensure that there is no feedback of contaminant into the water supply, the appliance must not be connected directly to the public drinking water supply mains. If the appliance is connected to potable water mains, backflow prevention devices should be incorporated in or fixed to the water supply system. The installation should be accepted by local boards or water supplier and should be conducted by professional technical personnel. The backflow prevention devices should be appropriate to fluid categories and comply with the requirement to avoid back siphonage according to EN 60335-2-79/A2: 2007. [. . . ] Please see your local dealer for list of authorised service centres in your area. This warranty does not cover belts, brushes, bags, bulbs or any part which ordinary wear and tear results in required replacement during warranty period. This warranty does not cover transportation cost or consumable items such as fuses and batteries. This limited warranty is void if the product's original identification (trade mark, serial number, etc. ) markings have been defaced, altered or removed or if product is not purchased from an authorised reseller or if product is sold AS IS and / or WITH ALL FAULTS. [. . . ]