User manual RYOBI RLH1100MKII-RLH1100MK2

[. . . ] Guard against electric shocks ­ avoid body contact with earthed surface (e. Hold the tool by insulated gripping surfaces when performing an operation where the cutting tool may contact hidden wiring. Make sure the cord is located so that it will not be stepped on, tripped over or otherwise subjected to damage or stress. Avoid accidental start-ups; make sure that the power switch is in "OFF" position before plugging in the power. [. . . ] Never stand or have any parts of your body in line with the path of the saw blade. Feed the work into the blade or cutter AGAINST the direction of rotation only. Never attempt to free a stalled blade without first turning the saw OFF. When transporting the machine use only transportation devices and never use guards for handling or transportation. During transportation the upper part of the saw blade should be covered. Use the extension table for supporting long workpieces during cutting operation. A: Support arm (6pcs) B: Rip fence assembly C: Leg stand (4pcs) D: Blade guard assembly E: Left extension table F: Right extension table G: Mitre gauge assembly H: Rear extension table I: Cross Brace (4pcs) J: Blister pack with screws K: Push stick Input voltage Watts Blade diameter Bore size No load speed Depth of cut at 90O Depth of cut at 45O Main table size Left/Right Extension table sizes Sound pressure level Net weight 230 V ~ 50 Hz 1500W 254mm 30mm 4500min-1 80mm 55mm 638mm x 430mm 638mm x 150mm (x2) 99dB(A) 23. When the noise level exceeds 85 dB (A) be sure to wear ear protection. This machine is designed to rip and cross cut wood exclusively up to maximum thickness of 80mm. For correct operation it must be fixed and operated as explained in this manual. DO NOT cut timber greater than 80mm DO NOT cut metal, stone, rubber, plastic bones, etc. The Blade(15) has been adjusted at the factory, use a square to check that the blade is at a 90o angle to the table (Fig. 10) If adjustment is needed turn the tilting lock nut (while holding the adjustment in position) to fix the adjustment. Then loosen the indicator fixing screw, set the indicator of the scale (12) on the "0o" marked then tighten the fixing screw (Fig. Turn the adjustment nut so that the blade is o on the 45 position and then tighten the lock nut. When the machine is connected with the power supply, the live indicator (26) will glow. If not, please check if the power plug is well connected Should the supply be interrupted the switch will automatically default to the "OFF" position preventing a dangerous unexpected startup of the machine when the supply is restored. WARNING: Before turning the machine ON, make sure he blade guard is correctly installed and operating properly. In the event that your saw turns off during operation, turn the saw off and allow the motor to cool down for approximately 3 minutes. If the saw does turn on, turn the switch off and check all cords for proper connection and retry. If it turns on and then cuts off while you are working, you may be trying to feed the workpiece too quickly or may be operating with a dull blade or may trying to operate on an insufficient voltage. Please note- this handle will move sideways as the tilt or bevel is adjusted. [. . . ] Hold the piece against the fence (6) and feed it through the blade (15) with a smooth, steady pressure. Always use the push stick (16) to feed the workpiece until it is clear of the table. When bevel ripping material of 6" (150mm) or narrower, use only the push stick(16) to feed the workplace past the saw blade. Fasten your dust collector to the back side of the table to the dust port(22) (Fig. [. . . ]